User manual KORG KP3

[. . . ] Using the unit in the following locations can result in a malfunction. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] At this point, you can either press the WRITE button (blinking) to save the changes you have made, or you can press the SHIFT button to exit without saving. NOTE While the TAP/RANGE button is lit orange, you can press the TAP/RANGE button to return to the preceding page. By resampling, you can create a sample that combines multiple existing samples, or create a new sample from an existing sample processed by an effect. Remember that with resampling, the output of the KP3 is being recorded, so all of the effects created using the touch pad will be recorded as part of the sample data. From here, follow the same instructions for loop and one shot sampling in the previous section. You can assign MIDI messages to the following controllers: PROGRAM/BPM knob, PROGRAM MEMORY 1­8, SAMPLE BANK A­D, FX DEPTH, LEVEL SLIDER, PAD (X, Y, TOUCH), and HOLD. Prog: This turns on/off the function that displays the program name in the touch pad LED when a program change occurs. ILLU: This specifies the illumination shown in the pad LED when a certain time has elapsed since you took your hand off the touch pad. NOTE Illumination will not operate if Hold is active, nor when you're making function settings. You can connect the KP3 to your computer and read/write the contents of the inserted card via USB. The KP3 will transmit the MIDI messages you assigned to each controller using the included PC editor. For the touch pad, you You can use an SD card to save or load data to and from the KP3's internal memory. You can also load samples (WAV files or AIFF files) created on a computer into the KP3 by using a card. Don't use your computer or digital camera to format (initialize) a card you plan to use with the KP3. If the card was formatted on a different device, it may not work correctly with the KP3. If you set the card's switch to the protected setting, it will be impossible to write or erase data on the card, or to format it. If you need to save edited data on the card, move the switch back to its original unprotected setting. The gold contacts should be facing down, and the angled corner to your right. Avoid using or storing SD cards in locations of extremely high or low temperature such as in direct sunlight, a closed automobile, or near a heater, or in locations of high humidity or excessive dust. Avoid using or storing SD cards in locations where they may be subject to strong static electricity or electrical noise. Do not allow dirt or foreign matter to adhere to the contacts of an SD card. If the contacts should become soiled, gently wipe them off using a dry cloth. [. . . ] If your computer is set so that the installer does not start up automatically, navigate to the CD-ROM and double-click "KorgSetup. NOTE You must install KORG USB-MIDI Driver Tools if you want to use Sample Librarian/ MIDI Editor via a USB port. When you've installed all of the software you selected, exit the installer. In order to use Sample Librarian/MIDI Editor via a USB connection, you must install the "KORG USB-MIDI driver" in your computer. [. . . ]