User manual KORG KM202

[. . . ] Mains powered apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] TAP button You can specify the BPM value by pressing this button at the desired interval. Turn this knob to the right produces a “switch” effect, turn the knob to the left produces a smoother transition. Please refer to the appendix for directions on how to change the crossfader settings. BOOTH OUT jacks These output the same audio signal as the MASTER OUT jacks. INPUT (LINE) jacks You can connect line level equipment to these jacks. GND terminal This is a grounding terminal for connecting your turntables. If you use the PHONO jacks, you must connect the ground wire(s) of your turntable(s) to this GND terminal. Getting ready Before you connect your equipment, you must turn off the power switches and disconnect the power cables from the outlet. Connections Use the jacks that are appropriate for the equipment you’re connecting. KM-402 PA Mixer TURNTABLE CD PLAYER KM-202 PA Mixer TURNTABLE CD PLAYER 7 Turning the power on When powering-on this Mixer, you must observe the following procedure. Power-on the external devices connected to the mixer’s input jacks. Turn down all of the Mixer’s channel faders and the MASTER VOLUME knob. Power-on the equipment connected to the MASTER OUT jacks, such as your monitor amp. Turn down all of the Mixer’s channel faders and the MASTER VOLUME knob. Turn off the power of your monitor amp or other equipment connected to the MASTER OUT jacks. Using the mixer Basic operation Selecting the inputs Use the top panel INPUT SELECT switch to select the desired inputs. Adjusting the input levels Use the TRIM knobs to adjust the input level of each mixer channel. Adjust the TRIM knob so that the level indicator lights yellow with the channel fader at the maximum position, and when the level from the source is being input at its maximum level. For the KM-202 Use the MIC LEVEL knob to adjust the input level of the mic connected to the MIC jack. Use the MIC BALANCE knob to adjust the level balance that is sent to mixer channels PGM1 and PGM2. Mixing the sound Use the channel faders to adjust the volume level of each mixer channel. Using the crossfader The audio mixed by the crossfader is output to the master bus or the FX bus. [. . . ] € If the sound is distorting at the EQ, make the following adjustment. Adjusting the crossfader You can adjust the left and right transition points of the crossfader. The Left setting determines where on the crossfader’s travel Channel B (KM-402) or PGM 2 (KM-202) will completely cease to sound. Likewise, the Right setting determines where on the crossfader's travel CH A (KM-402) or PGM A (KM-202) will cease to sound. [. . . ]