User manual KORG G5

[. . . ] E F G 2 To ELECTRIBE∙SX-SD Users Thank you for purchasing the Korg ELECTRIBE∙SX-SD Music Production Sampler. This product features the same basic functionality as the ELECTRIBE∙SX, but supports an SD card. Please read this booklet as well as the ELECTRIBE∙SX Owner’s Manual for information on using the new ELECTRIBE∙SX-SD. [. . . ] This booklet describes features that are new or modified relative to those from the ELECTRIBE∙SX. Please refer to the supplied Owner’s Manual for reference pages and the corresponding contents. Supporting an SD card The ELECTRIBE∙SX-SD uses an SD card, instead of SmartMedia™, to save internal data. Before using an SD card on the ELECTRIBE∙SX-SD, please note the following: • In the sections describing SmartMedia™ in the Owner’s Manual, please replace “SmartMedia™” instances with “SD card. € • Please replace the “Using SmartMedia™” section on page 84 with the following section. Before using an SD card for the first time, format the card on the ELECTRIBE∙SX-SD. If the card has been formatted by another device, the card may not be recognized by the ELECTRIBE∙SX-SD, or the unit may be unable to access the function parameters. Write-protect switch New AC power adapter The AC/AC power supply has been replaced with an AC adapter. Due to this change, the AC 9V jack on the rear panel has been modified. Please refer to the following illustration for the location of the power adapter jack and the power switch, instead of the figure on page 14. Protect AC adapter jack Power switch Handling an SD card Please read the instruction manual that came with the SD card. 2W About the vacuum tubes Immediately after you turn on the power to the unit, the vacuum tube may glow momentarily. Inserting an SD card Make sure that the SD card is oriented in the correct direction, and then insert it all the way into the card slot until it clicks into place. Korg would like to extend sincere thanks to the many artists who lent their time and talents for the creation of samples, sounds, patterns and demo songs in ELECTRIBE∙SX-SD: Anti-Pop Consortium BECK, Doug BRADSHOW, Ian Denkitribe Emika FISHER, Ian HIRATA, Tomoki KEMMEI mryat MUNYAK, Oliver SCHERCHEN, Michael STANCLIFFE, Bill THORPE, Tom Tyson, Cory 12 13 Notice regarding disposal (EU only) When this “crossed-out wheeled bin” symbol is displayed on the product, owner’s manual, battery, or battery package, it signifies that when you wish to dispose of this product, manual, package or battery you must do so in an approved manner. [. . . ] Inserting an SD card Make sure that the SD card is oriented in the correct direction, and then insert it all the way into the card slot until it clicks into place. Korg would like to extend sincere thanks to the many artists who lent their time and talents for the creation of samples, sounds, patterns and demo songs in ELECTRIBE∙SX-SD: Anti-Pop Consortium BECK, Doug BRADSHOW, Ian Denkitribe Emika FISHER, Ian HIRATA, Tomoki KEMMEI mryat MUNYAK, Oliver SCHERCHEN, Michael STANCLIFFE, Bill THORPE, Tom Tyson, Cory 12 13 Notice regarding disposal (EU only) When this “crossed-out wheeled bin” symbol is displayed on the product, owner’s manual, battery, or battery package, it signifies that when you wish to dispose of this product, manual, package or battery you must do so in an approved manner. Do not discard this product, manual, package or battery along with ordinary household waste. [. . . ]