User manual KORG AX10G

[. . . ] ) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. IMPORTANT READ THIS FIRST: How to read this manual In this manual, areas that are SHADED IN GRAY describe functions provided only by the DTR-2000. G Tuning mode indicator This will light to indicate the currently selected tuning mode. H MODE switch Use this switch to select a tuning mode other than Chromatic. I CHROMATIC switch Use this switch to move to Chromatic mode from another tuning mode. You can press this switch simultaneously with the DISPLAY switch to enter Sound mode. Parts and their functions Front panel I H G FE D C B A 0 Rear panel 9 8 76 5 4 3 2 1 9 6 5 4 3 2 1 1 POWER switch Turn down the volume of the connected amp, and press this switch to turn on the power. If you insert a plug into this jack, the rear panel INPUT jack (the INPUT 1 jack on the DTR-2000) cannot be used. When muting is on, the indicator beside the switch (the Mute indicator on the DTR-2000) will light, and the sound from the OUTPUT jack will be silenced. You can also connect a latch-type (alternate-type) switch to the MUTE jack and use it to switch muting on/off. DTR-2000 only: 0 INPUT select switch This switch selects whether to use the INPUT 1 or the INPUT 2 jack. If you want to use the mic, use the INPUT SELECT switch to select an INPUT jack that is not connected, and turn Mute on. B LIGHT switch This is an on/off switch for the lamp located in the lower middle of the front panel. C Meter unit display This will indicate the units (CENT or Hz) that you have selected for the tuning meter. D INPUT 1, 2 indicators (Input jack indicators) These will light to indicate the input jack (1 or 2) that is currently selected. cENT display The display will show a range of -50 cents–+50 cents. Tune your instrument so that the 0 (L) in the center of the meter is lit. STROBE display Tune your instrument so that the bars in the meter stop moving. dTR-2000 only: Hz display The display will show a range of -6 Hertz–+6 Hertz. Tune your instrument so that the 0 (L) in the center of the meter is lit. If the pitch of your instrument is outside the range of the display, the meter will be darker. [. . . ] The pitch will rise or fall in steps according to the tuning mode you selected. When you enter Sound mode, the reference tone will be "A" for Chromatic mode, or the lowest note for the other tuning modes. If you are producing sound on your instrument at the moment you enter Sound mode, the DTR-2000 will output the reference tone that is closest to that note. To exit Sound mode, simultaneously press the DISPLAY switch and the CHROMATIC switch. [. . . ]