User manual JVC KD-G152EX

[. . . ] Be sure to ground this unit to the car's chassis again after installation. It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear d'autoradios JVC. If the maximum power is less than 50 W, change · To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. [. . . ] If the maximum power is less than 50 W, change · To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. inférieure à 50 W , changez "Amp Gain" pour éviter d'endommager vos enceintes (voir page 22 du · The heat sink becomes very hot after use. DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car. If any item is missing, consult your JVC IN-CAR ENTERTAINMENT dealer immediately. If you have any questions or require information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits. If you are not sure how to install this unit correctly, have it installed by a qualified technician. Connectez le fil de commande à distance (bleu avec bande blanche) au fil de commande à distance de l'autre appareil de façon qu'il puisse être commandé via cet appareil. Y-connector (not supplied for this unit) Connecteur Y (non fourni avec cet autoradio) To the remote lead of other equipment or power aerial if any Au fil de télécommande de l'autre appareil ou à l'antenne automatique s'il y en a une You can connect amplifiers to upgrade your car stereo system. Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit. Disconnect the speakers from this unit, connect them to the amplifier. ­ The line output level of this unit is kept high to maintain the hi-fi sounds reproduced from this unit. When connecting an external amplifier to this unit, turn down the gain control on the external amplifier to obtain the best performance from this unit. Remote lead Fil d'alimentation à distance Remote lead (Blue with white stripe) Fil d'alimentation à distance (Bleu avec bande blanche) Metallic body or to the chassis of the car--to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). [. . . ] When connecting an external amplifier to this unit, turn down the gain control on the external amplifier to obtain the best performance from this unit. Remote lead Fil d'alimentation à distance Remote lead (Blue with white stripe) Fil d'alimentation à distance (Bleu avec bande blanche) Metallic body or to the chassis of the car--to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Player can be connected using an interface adapter (not supplied)--KS-PD100 (for iPod) or KS-PD500 (for D. [. . . ]