User manual JUNO JKU6031
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JUNO JKU6031. We hope that this JUNO JKU6031 user guide will be useful to you.
You may also download the following manuals related to this product:
JUNO JKU6031 (391 ko)
JUNO JKU6031 (381 ko)
JUNO JKU6031 (386 ko)
Manual abstract: user guide JUNO JKU6031
Detailed instructions for use are in the User's Guide.
[. . . ] It is dangerous to alter the specifications or modify this appliance in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish.
13
Location
Fig. 4
600
547 550
This appliance is designed to be built-in to a space having the dimensions given in Fig. 1.
Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4), and, using the screws removed from the lower part, fix it to the base of the appliance itself.
D510
820
820-870
59
6
D506
100-170
870
Fig. 2
The height of the appliance can be altered if required by means of adjustable feet situated at its base (Fig. 2).
Remove and refit the other hinge on the upper part of the appliance on the opposite side. Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side.
Fitting a decorative door panel
D507
Door reversibility
Remove the two screws which fix the upper hinge to the door.
Fig. 3
Carefully lean the appliance on its back and remove the plastic insert (Fig. 3).
Important: The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3. 5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins pre-fitted on the appliance door. 5
A
= =
D447
Remove the two screws which fix the lower hinge to the door. Remove the four screws which fix the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that fix the upper hinge to the appliance and remove the hinge itself.
D467
Place the appliance in the position where it is to be built in (Fig. The appliance is fitted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess.
Keeping the appliance central in the recess, slide it in until its back touches the wall. With a tape measure (or similar instrument), measure distance (A) between the top edge of the door and the top edge of the decorative panel, placing it next to the recess.
14
Fig. Position the top bracket on the panel, making sure that there is an equal distance between it and the sides and that its distance from the top edge is equal to distance (A) less 1 cm.
Secure the bracket with the screws supplied. Take care not to damage the front face of the panel whilst working.
Fig. 7
Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the fixings. Cover the visible part of the top bracket on the panel with plastic D472 cover (D), inserting it in the locations provided in the bracket.
D
Fig. 7) into their locations in the door and screw them in.
D517
Once the door has been correctly aligned, tighten the holding nuts on the fixing brackets and attach the appliance to the adjacent units and the bottom of the work surface (Fig. [. . . ] Use the special cleaner provided, which you will find already inserted into the drain hole.
Fig. 19
D037
18
MAINTENANCE
Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
Interior light
The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not come on when the door is open, check that it is screwed into place properly. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE JUNO JKU6031
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JUNO JKU6031 will begin.