User manual JONSERED ICT 13 REV 1

[. . . ] On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. Before attempting to start the engine, disengage all blade attachment clutches and shift into neutral. To guard against overturning; - do not stop or start suddenly when going up or downhill; - engage clutch slowly, always keep machine in gear, especially when traveling downhill; - machine speeds should be kept low on slopes and during tight turns; - stay alert for humps and hollows and other hidden hazards; - never mow across the face of the slope, unless the lawnmower is designed for this purpose. [. . . ] For proper bag function and appearance, it may be necessary to adjust the bagger assembly. There should be 6mm (1/ 4")-9mm (3/8") gap between the bagger top and fender and the bagger top surface should be even with the top surface of the fender. Loosen only enough so the brackets keep their position, but allow them to be moved. Move the brackets the amount forward or backward you wish the bag assembly to move. Loosen only enough so the brackets keep their position, but allow them to be moved. Move the brackets the amount up or down you wish the bag assembly to move. Make sure that the letter "A" on both the plug and handle are on the same side and that they can both be seen from the top when laying on the ground. Porte (trappe) Arrière 6 Console de support 53 Boulon de support 3/8 1 Contre-ècrou 3/8 Boulon à tête hèxagonale 3/8 x 63, 5 Rondelle plate 10, 3 (13/32") The accelerator control regulates the motor speed and also the speed of the blades. When the pedal is pushed down the brake is applied and the motor is disengaged. Gear changing can take place from neutral to top gear without stopping in each gear position. Stop the machine before changing from reverse to forward gear, or the opposite. Gear changing between the forward gears must not take place when the machine is in motion. Move the lever forwards to connect the drive to the cutting unit, whereby the drive belt is tensioned and the blades begin to rotate. If the lever is moved backwards the drive will be disconnected and the rotation of the blades slowed down by the action of the brake shoes on the pulley. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transporta-tion the cutting unit shall be in the highest position. There are three different positions for the ignition key: OFF All electric current broken. Never leave the key in the ignition lock when leaving the machine on its own. To release the parking brake all that is necessary is to push down the brake pedal. The wheel is easier to turn if the lever for lifting/lowering of the cutting unit is pulled backwards at the same time. Do not smoke when filling with petrol or fill up when the engine is warm. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. [. . . ] NOTE: Three full turns of adjustment nut will change mower height about 1/8". Engage the parking brake and work off the belt upwards from the pulley (2), the clutch pulley (3). The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows: · NOTE: If additional clearance is needed to get to adjustment bolt, mowe mower deck height to the lowest position. [. . . ]