User manual JBSYSTEMS CLS-2 15B V1.2

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JBSYSTEMS CLS-2 15B. We hope that this JBSYSTEMS CLS-2 15B user guide will be useful to you.


JBSYSTEMS CLS-2 15B V1.2: Download the complete user guide (695 Ko)

Manual abstract: user guide JBSYSTEMS CLS-2 15BV1.2

Detailed instructions for use are in the User's Guide.

[. . . ] Reproduction or publication of the content, even portions, in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. [. . . ] Therefore this speaker is intended for indoor use only, use of this product outdoors, in humid conditions, voids all warranties. A) Woofers separated: Used when you only install 1 subwoofer or when the amplifier is not powerful enough to drive 1 subwoofer per channel. IMPORTANT: Both inputs must be connected and the amplifier must be set to MONO mode (NOT Bridge!) ® Both woofers inside the cabinet have their own Speakon input connector. This means that you can connect the left output of an amplifier to the left input of the subwoofer and the other amplifier output to the right Speakon® input. (2x 1200Wpeak) B) Woofers in parallel: Used when you have powerful amplifiers that can deliver the high power needed by the subwoofer. Attention: when a second subwoofer is connected, the impedance drops from 4 to 2!Please note that most amplifiers do not support heavy working conditions while under 2 load. moreover the damping factor of your amplifier drops significantly resulting in a weaker bass response. Preferred setup combination: When used with the CLS-8 mid/high cabinets you should try to keep a certain balance with this subwoofer to make a good sounding system. You should use 2 separate amplifiers plus an active crossover or audio processor crossed at +/-130Hz (24dB/oct). Of course you are not limited to this combination, you can experiment with other setups as much as you like!Speakon® wiring is made as follows: POSITIVE = +1 and +2 NEGATIVE = -1 and -2 Cables to be used: You can use readymade cables but of course you can also assemble the speaker cables yourself. Be sure to connect the same color on each side of the cable to the ® corresponding contact: +1 to +1 and -1 to -1. [. . . ] Support de connexion d'entrée Sur ce support de connexion se trouve un interrupteur protégé par un couvercle transparent. Zeer stevige multiplex klankkast met: Duurzame krasbestendige verf Metalen handvaten Stalen front grill Aan de achterkant zijn bevestigingspunten voorzien voor wielen (in optie verkrijgbaar) Uitgerust met 2 high power 15" woofers met ALU korf Kan perfect gecombineerd worden met 4x CLS-8 mid/high klankkasten [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JBSYSTEMS CLS-2 15B




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JBSYSTEMS CLS-2 15B will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.