User manual JBL ONBEAT

[. . . ] If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. 12. [. . . ] To hear only one source, you will need to turn off the other source (the one you do not want to hear) manually. DC IN POWER AUDIO IN USB VIDEO OUT USB Type B IMPORTANT NOTE FOR ALL ELECTRONIC PRODUCTS: Before inserting or unplugging audio cables from the device's Audio In jack, it is good practice to turn off the device first. This will prolong the life of your unit, help protect it from static electricity and prevent potential damage. 4. If you want to view videos or photos from your iPod, iPhone or iPad device on a TV, plug one end of a composite video cable (not included) into the JBL OnBeat speaker dock Video Out connector, and plug the other end into your TV's composite video input connector. Your JBL OnBeat speaker dock includes two adapter clips: one for an iPod touch®/iPod classic®/iPhone device, and another for an iPad device (NOTE: the iPod 5G and iPod nano® models do not require an adapter clip. ) The adapters allow you to dock units with or without third-party skins attached. Attach the appropriate adapter clip to the JBL OnBeat speaker dockdock as shown below. Composite Video iPod touch/iPhone iPad Locking Hole When you dock your iPod, iPhone or iPad device on the JBL OnBeat speaker dock, its video output will automatically be set to Off, even if it was turned On before you docked the device. To turn the JBL OnBeat speaker dock video output on, press the remote's Menu button for at least two seconds. The video from the iPod, iPhone or iPad device will play on the connected TV. To turn the video output off, press the remote's Menu button again for at least two seconds. Insert the included AC cord all the way into the power supply (if there is more than one AC cord, use the correct one for your region). Then connect the power supply into the JBL OnBeat speaker dock DC In connector and plug it into an AC wall outlet. Insert Pin Into Locking Hole Bend Clip Slightly Bend Clip Slightly DC 12V AUDIO IN USB VIDEO OUT 7. Press the top of the iPod/iPhone/iPad device all the way back into the adapter clip or against the dock to secure it in the dock. 4 USING YOUR JBL ONBEAT SPEAKER DOCK To turn the JBL OnBeat speaker dock on, press the Power button on the unit. To turn the JBL OnBeat speaker dock off, press the Power button on the unit again. To place the JBL OnBeat speaker dock into the Standby mode while an iPod, iPhone or iPad device is docked, hold down the Play/Pause button on the remote for two seconds. [. . . ] 6 White ­ Constant White ­ Flashing Amber ­ Constant No LED JBL OnBeat speaker dock is on JBL OnBeat speaker dock is muted JBL OnBeat speaker dock is in Standby mode JBL OnBeat speaker dock is off TROUBLESHOOTING YOUR JBL ONBEAT SPEAKER DOCK PROBLEM SOLUTION dock and to a working AC outlet. docked in the JBL OnBeat speaker dock. connected to the JBL OnBeat speaker dock Audio In connector and to the source component's audio output. Pause mode and that its volume control is not turned all the way down. dock Audio In jack. docking connector. [. . . ]