User manual JANE EXO

[. . . ] Not all safety systems are exactly the same, therefore we recommend you test your EXO in the vehicle in which it is going to be fitted. It is very important not to use second-hand products, since JANÉ can only guarantee complete safety for articles used by the original buyer. JANÉ recommends you replace your EXO seat with a new one when it has been subjected to significant strain after an accident. [. . . ] Preferably on rear seats and never on seats that are fitted with a frontal airbag. If you want to install the seat with the ISOFIX fasteners, make sure that the vehicle seat is fitted with the fasteners. 1b Guide both fasteners towards the axles and press until both sides are locked, two green lights on the front panel (11b) or two green signals on the fasteners (10) will indicate that both are fastened. 1c Pulling the fastener extraction lever again (12), press the seat against the backrest of the vehicle. Continue to press while releasing the lever and the fasteners will remain immobile. 1f Lastly, tighten the strap until the red signal disappears from the tension indicator (14c). You can store the ISOfix fasteners by pulling the front lever (12) and pressing the fasteners inside the base. A Place the EXO seat in its most reclined position (see 5, adjusting the backrest) and turn the tightening lever (18) towards the rear part of the seat. Pass the buckle of the three-point seat belt between the base and the seat (15) and fasten it. B Slide the shoulder strap of the vehicle seat belt through the clip (16) on the top part of the seat, only the one on the side opposite to the buckle. C Press the EXO against the seat and manually tighten the vehicle seat belt. D Pass the strap through the red ring (17) of the seat E Lastly, turn the tightening lever (18) towards the front of the seat. To make it easier to install the baby in the seat, you can fasten the seat belts in the side straps. C Position the baby in the seat making sure that he is sitting as far back as possible and with the backrest upright. [. . . ] To find out the current state of the ISOfix fasteners after installation, press the "TEST" key. The central (11c) will flash when the batteries are about to wear out. Recycling and maintenance This detection system should be recycled in accordance with directive 2002/96/EC. [. . . ]