User manual FRANKE SGP 62 M BK/F

[. . . ] Switching on the first time How to read the cooking table This user manual applies to several models of the device. Thus it may be possible that some of the described features and functions are not available on your specific model. The explanatory images and figures, described in the various sections, are available at the end of the manual. Franke reserves the right to make Modifications to the product without prior notice. [. . . ] In this case the fast radiant surface cooking keeps the meat tender on the inside; the grill can also be used to quickly toast up to 9 slices of bread. The Franke oven is designed to grill food with the oven door completely closed. Note: The grill heating element is very hot when in use; be careful not to touch it accidentally when handling food inside the oven. In any case, Franke has designed the oven opening to protect hands as much as possible. TURBO GRILL COOKING The grill heating element at the top of the oven and the fan are activated. It combines one-way heat radiation with forced air circulation inside the oven. This prevents the surface of the food from burning and allows the heat to penetrate deeper. Excellent results are obtained using the turbogrill for mixed meat and vegetable kebabs, sausages, spare-ribs and lamb chops, broiled chicken, quail with sage, pork fillets, etc. 220°C, however a lower temperature can be set, in which case grilling will be slower. At the end of cooking, the ringer will Sound for 1 minute; this sound can be Stopped by pressing the knob. Setting the time of day XXTo set the correct time, just press the knob three times (the LED for the clock symbol starts blinking), then turn the knob. 1b) End of cooking timer knob (B) The end of cooking timer is a practical device that turns the oven off automatically at a set time in an interval of 1 to 120 minutes. 99 To use the end of cooking timer, the ringer Must be wound up by turning the knob (B) almost one full turn clockwise; then, turning back, set the required time by aligning the number corresponding to the minutes with the fixed reference on the front panel. At the end of the set time, the ringer Sounds and the oven is automatically switched off. Note: The oven stays hot at around the set cooking temperature for a long time after it has been switched off; therefore to avoid overcooking or burning the food, it is advisable to remove it from the oven. Without using the end of cooking timer, align the knob (B) pointer with the fixed symbol on the front panel. When the oven is turned off, the end of cooking programmer can be used as a normal timer. 1a) It enables oven programming in the following modes: ­­ delayed start of cooking with set duration, ­­ immediate start of cooking with set Setting the digital clock When the appliance has been connected to the mains or after a power failure the display will flash on: , , 0. The time of day can be adjusted with the + and - buttons, while the dot between the hours and minutes flashes. b If the time setting mode is selected when an automatic programme is active, the automatic programme is cancelled. Possible time adjustments can be made by repeating the steps described above. Acoustic signal frequency modification The frequency of the acoustic signal can be changed if a cooking cycle is not programmed (therefore the display shows the time of day). [. . . ] Left area at the back Follows: XXTurn off the power to the appliance by Means of the omnipolar switch used for XXUnscrew the glass cover (A). XXUnscrew the lamp and replace it with one ?­ Connection: G9 XXRefit the glass cover (A) and reconnect the Power supply voltage and frequency Total power and fuse rating Power and heating elements Upper Lower Grill Fan Tangential fan Oven lamp In the event of any operation problems, contact a Franke Technical Service Centre (refer to the attached list). Specify: ­­ the type of fault; ­­ the appliance model (Art. This information is given on the appliance dataplate on the warranty certificate. [. . . ]