User manual FRANKE FGL6015XS

[. . . ] INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. € The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). € Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. [. . . ] € Do not flambè under the range hood; risk of fire • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. € Children should be supervised to ensure that they do not play with the appliance. MAINTENANCE • Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. € Clean and/or replace the Filters after the specified time period (Fire hazard). The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 116 116 306 Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. € Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above the horizontal reference line. € Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Net 5 5 Mounting the hood body • Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. € To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. € Fix the pipe in position using sufficient pipe clamps (not supplied). ø 150 9 ø 120 RECIRCULATION VERSION AIR OUTLET • Insert the connection extension pieces laterally 14. [. . . ] € Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. € When refitting the filters, make sure that the handle is visible on the outside. Activated charcoal filter (Recirculation version) REPLACING THE ACTIVATED CHARCOAL FILTER • The filter is not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently for particularly heavy usage. [. . . ]