User manual FRANKE FDW 613 E6P

[. . . ] In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. After installation, remove the stoppers from the racks and the retaining elastic elements from the upper rack. [. . . ] In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. Load delicate and light dishes: glasses, cups, saucers, low salad bowls. Large plates and lids should ideally be placed at the sides to avoid interferences with the spray arm. (loading example for the upper rack) (loading example for the lower rack) The height of the upper rack can be adjusted: high position to place bulky crockery in the lower basket and low position to make the most of the tip-up supports by creating more space upwards and avoid collision with the items loaded into lower rack. The upper rack is equipped with a Upper Rack height adjuster (see figure), without pressing the levers, lift it up by simply holding the rack sides, as soon as the rack is stable in its upper position. To restore to the lower position, press the levers A at the sides of the rack and move the basket downwards. We strongly recommend that you do not adjust the height of the rack when it is loaded. The basket is equipped with top grilles for improved cutlery arrangement. The cutlery basket should be positioned only at the front of the lower rack. Knives and other utensils with sharp edges must be placed in the cutlery basket with the points facing downwards or they must be positioned horizontally in the tip-up compartments on the upper rack. The side foldable flaps can be positioned at three different heights to optimize the arrangement of crockery inside the rack. Wine glasses can be placed safely in the foldable flaps by inserting the stem of each glass into the corresponding slots. To change the inclination, pull up the foldable flap, slide it slightly and position it as you wish. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. Regularly clean the filter assembly so that the filters do not clog and that the waste water flows away correctly. The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water: to obtain the best washing results, you need to keep them clean. The dishwasher must not be used without filters or if the filter is loose. After several washes, check the filter assembly and if necessary clean it thoroughly under running water, using a non-metallic brush and following the instructions below: 1. The detergent has not been measured out correctly or it is not suitable for use in dishwashers (see FILLING THE DETERGENT DISPENSER). Reset the current cycle by switching OFF the dishwasher, then switch it on again, select a new program and close the door. The dishes are not The crockery has not been arranged prop- Arrange the crockery correctly (see LOADING THE RACKS). The spray arms cannot rotate freely, being Arrange the crockery correctly (see LOADING THE RACKS). [. . . ] In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e. [. . . ]