User manual FOSTEX MTC-1

[. . . ] Use the Data wheel or the [ /-1] or [+1/ then press the [ENTER] key. ] key to select the desired EQ program number and name, The following warning message appears, asking you if you wish to continue. [. . . ] Please read this addendum along with the User's Guide. The MTC-1 deletes the selected Library data and returns to Channel Edit mode. <Deleting a user scene> 1. Press the [RECALL] key and [STORE] key in the Scene Memory section simultaneously. The MTC-1 displays the SCENE MEMORY: CLEAR function page. 2. Use the Data wheel or the [ /-1] or [+1/ name, then press the [ENTER] key. ] key to select the desired scene program number and The following warning message appears, asking you if you wish to continue. If you wish to cancel the operation, press the [EXIT] key. The MTC-1 deletes the selected scene data and returns to Channel Edit mode. <A scene recalled after initializing> With the previous version, when you initialize the MTC-1 settings by selecting "ALL" for the INITIALIZE ITEM parameter on the SETUP: SYSTEM 6: INITIALIZE function page, the current scene display is not refreshed. Channel sound will fade in or out slowly. FAST SLW <New version> <SOLO GAIN function> The SOLO GAIN parameter enables you to adjust a solo channel's master gain. Turn the EQ HI [Q] control counter-clockwise to lower the gain. * One of the Eff2 presets, "38:3D CHORUS" in the Effect Library has changed to "35: Dual DELAY. " When you press the [EFF2] key in the Eff Edit section, the following page appears. <Old version> <New version> * Another new function enables you to delete any user effect programs, EQ programs, or scenes, using the following steps. <Deleting a user effect program> 1. Press the [RECALL] key and [STORE] key in the Eff Library section simultaneously. The MTC-1 displays the EFF LIBRARY: CLEAR function page. * On the 2: CH COPY and 3: EQ COPY pages in the CH View section, some indications (that appear after you select the source channel to copy) have been changed as shown in the circles below: <Old version> <New version> 2. Use the Data wheel or the [ and press the ENTER key. /-1] or [+1/ ] key to select the desired effect program number and name, The following warning message appears, asking you if you wish to continue. [. . . ] Use the Data wheel or the [ and press the ENTER key. /-1] or [+1/ ] key to select the desired effect program number and name, The following warning message appears, asking you if you wish to continue. [. . . ]