User manual FOSTEX AP3090

[. . . ] ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU' AU FOND. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosurethatmaybeofsufficientmagnitudetoconstitutea risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. "WARNING" "TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. " SAFETY INSTRUCTIONS 1. 5. 6. Read Instructions - All the safety and operating instructions should be read before the appliance is operated. Retain Instructions - The safety and operating instructions should be retained for future reference. [. . . ] 4. Display The 128 x 64 dot-matrix display using organic EL devices shows the VU (needle) and peak (bar-graph) meters, batterystatus, etc. Whenyoufirstturnonthe unit after purchasing, the stereo VU and peak meters are shown. 9. 10 10. Monitor select switch This switch selects the signal monitored by the headphones connected to the [PHONE] jacks (1/4-inch and mini). AUX RTN L ST R L+R MS L-R Signals input to the [AUX IN] connector. Signals output from the [MAIN OUT L and R] connectors in mono (L component of MS). R component of MS is output in mono. <Memo>: When you select the [LIMITER] switch to ON or LINK, the meter display shows "LIM" (pointed by arrows below). When the limiter is working, "LIM" flashes. Thefollowingshowsdisplayexamplesofthe stereo meter display. When the switch is set to OFF When the switch is set to ON or LINK 11. [STATUS] / [EDIT] key Holding down this key for a second or more enters the status mode. In this mode, you can switch among status display pages as well as you can edit parameters (see page 15). In the brightness adjustment mode, meter selection mode or status display mode, this key acts as the [EDIT] key (see page15). Pressingthiskeybrieflyexitsthecurrentmode while pressing this key for a second or more enters or exits the parameter editing mode. 1/4-inch [PHONES] jack You can connect stereo headphones with the 1/4-inch plug for monitoring. Headphones level control This control is used to adjust the output level of both the 1/4-inch and mini [PHONES] jacks. [LIMITER] switch (ON, OFF, LINK) This switch enables or disables the limiter function. The limiter circuit is inserted after the MASTER fader. LINK The limiter function is enabled with the left and right channels linked. If either of left and right channel signals exceeds the threshold, both the left and right channel limiters work in the same way. You should set the switch to MIC when a microphone is connected to the input connector. You can supply the microphone power when connecting a condenser microphone (see "Microphone power supply switch" below). 7. [DC OUT 7. 2-24V] connector This connector outputs power at DC 7. 2 ~ 24 V / 0. 5 A for a wireless receiver, etc. Connector: Hirose 4-pin HR10A-7R-4S (female) 1 2 4 3 GND NC DC7. 2 to 24V NC 4. MIC 12 Right side panel section 1. [MAIN OUT] (L, R) connectors These connectors output stereo buss L and R signals. You can select the output reference level using the MAIN OUT level select switch described below. Connector: XLR-3-32 type 1 2 3 GND HOT COLD 7. AUX OUT level select switch This switch selects the output reference level of the [AUX OUT] connector between -10 dBV and -60 dBV. AUX OUT select switch This switch selects the output signal source of the [AUX OUT] connector. OFF 1/2 2/3 No signal is output. Stereo buss L and R signals are output in mono. 8. 2. MAIN OUT level select switches Each switch selects the output level of the [MAIN OUT] L or R connector. You can select the reference level of L and R connectors independently from +4 dBu, 0 dBu, -20 dBu and -60 dBu. [SUB OUT] connector This connector outputs the same signals as the [MAIN OUT] (L, R) connectors. The output reference level can be selected using the SUB OUT level select switch (described below). Connector: XLR-5-52 type 1 2 4 3 5 GND L-HOT L-COLD R-HOT R-COLD 1/3 L/R L+R 3. 9. [AUX OUT] jack This jack outputs the signal selected by the AUX OUT select switch described above. [. . . ] ADD: C/Laguna 10, 28923 Alcorcon, Madrid, Spain TEL: (+34) 91-4862800, 91-4470898, FAX: (+34) 91-6414597 NAME: Sennheiser France ADD: 128 bis, avenue Jean-Jaures, 94851 Ivry-sur-Seine Cedex, France TEL: (+33) 1 4987 0300, FAX: (+33) 1 4987 0324 <SWEDEN> <GERMANY> NAME: Benum Nordic A/S ADD: Aldermansvagen 17, 171 48 Solna, Sweden TEL: (+46) 8 207710 NAME: Mega Audio GmbH ADD: Stromberger Str. 32, D-55411 Bingen, Germany TEL: (+49) 6721-94330, FAX: (+49) 6721-32046 <SWITZERLAND> <GREECE> NAME: Audio Bauer Pro AG ADD: Bernerstrasse-Nord 182, CH-8064 Zurich, Switzerland TEL: (+41) 1-4323230, FAX: (+41) 1-4326558 NAME: Bon Studio S. ADD: 6 Zaimi Street, Exarchia, 106. 83 Athens, Greece TEL: (+30) 210-3809-605, 606, 607, 608 FAX: (+30) 210-3845-755, 210-3827-868 <UK> <ICELAND> NAME: SCV London ADD: 40 Chigwell Lane, Oakwood Hill Industrial Estate, Loughton, Essex IG10 3NY U. ADD: ARMULA 38 108 REYKJAVIK, ICELAND TEL: (+354) 588 5010, FAX: (+354) 588 5011 24 FOR THE US CUSTOMERS ONLY FOSTEX AMERICA LIMITED WARRANTY The following statement defines specific legal rights. [. . . ]