User manual FOCAL K2 POWER

[. . . ] TN 52 with inverted tweeter dome: Inverted dome formed from titanium treated Tioxid 5 material. Controlled with twin radius wave guides, for totally controlled staging and directivity. Due to constant technological advances, Focal reserves its right to modify specifications without notice. Tweeter The TN52 tweeter has been designed for flush mount or surface mount positioning, using the two fixing kits provided. [. . . ] Easily positioned behind the woofer, on the metal-work of the vehicle, Plain Chant soaks-up vibrations as well as acoustic reflections. Always ensure before that enough space is available for the magnet assembly, that it doesn't interfere with safety mechanisms or general working parts. In the case of not using the grilles supplied, it is important to ensure the speakers will fit correctly. Ensuring there is enough depth behind the speaker has already been explained, but enough thought must also be given for the forward movement of the cone and surround assembly. Woofer and woofer-midrange installation, simple steps (with grille) Either cut the required hole or use the correct hole of choice. Where necessary, carefully push in the four fixing clips to accept the fixing screws later. Carefully place the fixing ring, ensuring it lines-up with the holes or fixing clip positions. Add a small amount of glue where necessary, so it remains in the correct position (line-up holes). Lower the drive unit above the fixing ring, so it remains in the correct position (line-up holes). Now lower the drive unit and screw in place, with the 4 screws provided. Crossover installation, simple steps First before any work is started it is necessary to remove the clear plastic lid (fig. Remove, by pushing gently on the two shortest sides of the clear plastic lid. Never use a screwdriver to prise off the lid, otherwise damage will probably occur, not covered by the warranty. Always ensure the crossover is installed in a dry and vented area, without risk of humidity. 2-Way kits connecting up, simple steps Connect the output from the amplifier into the input of the crossover "IN". Finally always ensure the tweeter and woofer are connected in phase correctly, thus polarities are respected "+" to "+", and "-" to "-". If not done correctly a "hole" or "peak", may result, due to a shift in phase. The exclusive 165 KBP low frequency cross-over, has two configurations for filtering. I, and K), for a true 3 way set-up, with separate bass mid and high frequencies. J, and L), for a 2+1 way set-up, with 2x165mm in parallel, for more dynamic fast bass. Important (165K3P) Depending on the preferred set-up, the selector found in the 165KBP must , be switched accordingly. Because this mode has a low impedance value of approximately 2 ohms, verify if the low loading is compatible for your amplifier. [. . . ] Fitting the drive units low in the vehicle, especially in the bottom of the door for example, requires the mode "Mid High" to be used. Doing so will ensure such normally directional frequencies are not "masked" or lost in the textiles of the vehicle (fig. Your Focal-JMlab product was developed and manufactured with high-quality materials and components which can be recycled and/or re-used. This symbol indicates that electrical and electronic equipment must be disposed of separately from normal garbage at the end of its operational lifetime. [. . . ]