User manual FLASH THERMOFLASH DIGI 2 HF

[. . . ] - "frost protection" temperature : this is the minimum temperature for long absences. The IP43 wall mounting receiver can be easily installed close to the boiler. Important : the transmitter and receiver assembly is factory coded and is therefore immediately operational. [. . . ] From the "Auto" mode press the PROG P1-P4 button P3 = Comfort temperature from 6 a. Press the DAYS 1-7 button until a pointer appears under the day you wish to programme (Friday in our example). Press the PROG P1-P4 button until the P4 programme number flashes in the right side of the screen. Your display panel indicates time as 00:00 and the first thermometer flashes on the 24-hour profile. P4 = Blank programme allowing you to create 3 comfort temperature periods and 3 reduced periods for each day of the week. Set the time using the +/­ buttons (the numbers run off more quickly when the button is pressed continuously). This modification ends with the next change in programmed temperature. to return to the initial programme press "Mode" and re-position the pointer under "Auto". The current temperature level indicator (comfort or reduced) will stop flashing when the temporary modification comes to an end. POSSIBLE SETTINGS Various settings can be made on the back of the device (when it is not mounted). Button several times to obtain 22:00 This mode protects your dwelling from freezing by maintaining a minimum adjustable temperature in your dwelling during your absences (from 1 to 99 days). You can programme the length of your absence so that the temperature rises for your return. 2 different settings are available for maintaining If you make a mistake (e. 11:30 instead of 12:00) use the + and - buttons to advance or return and correct with the and thermometer buttons. Operating range : 75 m from transmitter to receiver in a free field (operates over 3 building floors) · Using + keys, set the length of your absence in days (from 1 to 99 days). With the "DAYS 1-7" button select the day from 1 to 7 and check your programming on the 24-hour profile at the bottom of the display panel (see example above). You pass into automatic mode by pressing the "MODE" button until the pointer appears under "Auto". In automatic mode the clock thermostat adapts to your life style by running the proMODE MODE grams you have selected. [. . . ] The indicator light OK of the receiver stops flickering, showing that the transmission / reception link has been established. - The OK indicator light stops flickering and this transmitter/receiver link is removed. Return the switch located at the back of the Thermoflash Digi 2 to the AUTO position. [. . . ]