User manual FALCON CLASSIC 90 CERAMIC

[. . . ] It should give you many years trouble-free cooking if installed and operated correctly. It is, therefore, important that you read this section before you start, particularly if you have not used a dual fuel cooker before. Using it for any other purpose could invalidate any warranty or liability claim. In particular, the oven should NOT be used for heating the kitchen - besides invalidating claims, this wastes fuel and may overheat the control knobs. [. . . ] Is the pan being used on the runners, not the floor of the compartment?Yes, this is caused by heat rising from the oven or the grill, and heating them up. Make sure that the grill pan is pushed right back to the `back stop' when grilling. If there is an installation problem and I don't get my original installer to come back to fix it, who pays?Service organisations will charge for their callouts if they are correcting work carried out by your original installer. Therefore, it's in your own interest to keep track of this installer so that you can contact them as required. In the event of a failure in the electrical supply, remember to reset the clock to ensure that the timed oven continues to operate. Check that you are using the recommended temperatures and shelf positions ­- see the oven cooking guide. Before removing the existing bulb, turn off the power supply and ensure that the oven is cool. Locate the bulb cover and unscrew it by turning it anticlockwise (it may be very stiff ): The oven is not cooking evenly. Do not use a baking tray with dimensions larger than those specified in the section on 'General Oven Tips'. If you are cooking a large item, be prepared to turn it round during cooking. If two shelves are used, check that space has been left for the heat to circulate. When a baking tray is put into the oven, ensure that it is placed centrally on the shelf. Check that the door seal is not damaged and that the door catch is adjusted so that the door is held firmly against the seal. A dish of water when placed on the shelf should be the same depth all over. (For example, if it is deeper at the back, then the back of the cooker should be raised up or the front lowered). If the cooker is not level arrange for your supplier to level it for you. Now unscrew the existing bulb anticlockwise, taking care to protect your fingers with a glove in case the bulb should shatter. 324-0007 Unscrewing the bulb cover The timed oven is not coming on when turned on manually. Is the key symbol () showing in the display to signify that the oven is locked?See the 'Clock' section of the instructions for more information on the key lock feature. [. . . ] If it is not possible to disconnect the leads in this way, pull cooker forward to gain access to the rear, remove screws securing the electric cover to the back sheet and remove cover and disconnect the terminals from the rear. To Remove Right-Hand Oven Inner Back Open right-hand oven door and remove the screws and washers securing the inner back to the back of the oven. To Change the Fan in the Right-hand Oven Disconnect from the electricity supply. Remove the screws securing the electric cover to the back sheet and remove the cover. [. . . ]