User manual ELECTROLUX Z4520

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ELECTROLUX Z4520. We hope that this ELECTROLUX Z4520 user guide will be useful to you.


ELECTROLUX Z4520 : Download the complete user guide (3372 Ko)

Manual abstract: user guide ELECTROLUX Z4520

Detailed instructions for use are in the User's Guide.

[. . . ] Electrical cable precautions: · A damaged cable must be replaced by an authorised Electrolux service engineer. · Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. All service and repairs must be carried out by an authorised Electrolux service engineer. on board 11 3 Z45xx_ifu_2. qxp 2005. 04. 27. 10:59 Page 4 BEFORE STARTING 1 2 3 4 1 2 3 Open the dustbag cover. [. . . ] 4 5 6 5 6 4 5 6 Open the filter grill to remove the exhaust filter. Close the filter cover. Note: Do not use cleaning agents and avoid touching the delicate filter surface. 6 Z45xx_ifu_2. qxp 2005. 04. 27. 10:59 Page 7 CLEANING THE HOSE AND NOZZLE The vacuum cleaner stops automatically if the nozzle, tube or hose becomes blocked, or the filter and dustbag are blocked. Disconnect from the mains and allow the vacuum cleaner to cool down for approximately 20-30 minutes. Clear whatever is causing the blockage and/or replace dirty filters or the full dustbag. Tubes and hose 1 Use a cleaning strip or similiar to clear the tubes and hose. 2 It is sometimes possible to clear the hose by "massaging" it. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to hoses caused by cleaning them. Cleaning the floor nozzle 3 To avoid reduction in suction power, frequently clean the dual purpose floor nozzle. The easiest way to clean it is by using the hose handle. 1 2 3 7 Z45xx_ifu_2. qxp 2005. 04. 27. 10:59 Page 8 TROUBLESHOOTING AND CUSTOMER INFORMATION Troubleshooting The vacuum cleaner does not start 1 Check that the cable is connected to the mains. Water has entered the vacuum cleaner It will be necessary to replace the motor by an authorised Electrolux service engineer. Damage to the motor caused by the penetration of water is not covered by the warranty. Customer Information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. For futher details see our website: www. electrolux. com For repairs or accessories, contact the Electrolux Group Floorcare Helpline on 08706 055 055. If you have any comments on the cleaner or the Instructions for Use booklet please contact us on 08706 055 055. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 8 Z45xx_ifu_2. qxp 2005. 04. 27. 11:00 Page 9 ELECTRICAL SUPPLY INSTRUCTIONS Before you start . . . check the voltage Before connecting the cleaner to an electrical supply ensure that voltage marked on the data plate (on the underside of cleaner) is correct for your electrical supply. Connecting to your electrical supply Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse and the fuse cover mustbe replaced before the plus is used again. In the event ofloss of the fuse cover, replacements can be obtained from your Electrolux dealer or Electricity Board and must be of the same colour as indicated by the coloured insert on the base plug. [. . . ] · Replace the top cover of the plug and secure. 9 Z45xx_ifu_2. qxp 2005. 04. 27. 11:00 Page 10 When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL THE INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. WARNING To reduce the risk of fire, electric shock, or injury: · Do not use out doors or on wet surfaces. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service centre before using. The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as filters, brushes and dust bags as the life of these depends upon the amount and nature of use. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ELECTROLUX Z4520




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ELECTROLUX Z4520 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.