User manual ELECTROLUX EC3340AOW

[. . . ] You’ve chosen a product that brings with it decades of professional experience and innovation. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. Com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. [. . . ] You confirm the choice of the temperature by pressing the Confirmation button. The temperature indicator shows again the inside compartment temperature. After a long period out of use it is not necessary to set again the temperature because it remains stored. During the stability period by the first starting the temperature displayed can not correspond to the setting temperature. During this time it is possible that the temperature displayed is different than the setting temperature. Difference between the temperature displayed and temperature setting is normal. Especially when: • a new setting has recently been selected • the door has been left open for a long time • warm food has been placed in the compartment Difference until 5°C inside the compartment are quite normal. During normal functioning the indicator shows the warmest temperature inside the compartment. 5 Functions Menu By activating the Function button the functions menu is operating. If there is no confirmation after some seconds the display will go out from the menu and return in normal condition. The following functions are indicated: Excessive temperature alarm Child Lock function Eco Mode function Frostmatic function Drinks Chill function 3. 6 Excessive temperature alarm An increase in the temperature in a compartment (for example due to an power failure) is indicated by: • flashing the alarm and freezer temperature indicators • sounding of buzzer When normal conditions are restored: • the acoustic signal shuts off • the temperature value continues to flash When you press the Confirmation button to de-activate the alarm, the highest temperature reached in the compartment appears on the temperature indicator for some seconds. Then it returns on the normal operation showing the temperature of the selected compartment. During the alarm phase, the buzzer can be switched off by pressing the Confirmation button. possible causes of alarm: • Large volume of fresh food was inserted. 7 Child Lock Function The Child Lock function is activated by pressing the Function button (several ENGLISH 25 times if necessary) until the corresponding icon appears . You must confirm the choice by pressing the Confirmation button within few seconds. In this condition any possible operation through the keys does not cause any change as long as this function is activated. It is possible to de-activate the function at any time by pressing the Function button until the corresponding icon will flash and then the Confirmation button. 9 Frostmatic Function The freezer compartment is suitable for long term storage of commercially frozen and deep-frozen food, and for freezing fresh food. The maximum quantity of foods to freeze in 24 hours is shown on the serial number plate. To freeze fresh foods, you will need to activate the Frostmatic function. [. . . ] There are some sounds during normal use (compressor, refrigerant circulation). Com Problem The appliance is noisy Possible cause The appliance is not supported properly Solution Check if the appliance stands stable (all the four feet should be on the floor) Set a warmer temperature Do not leave the lid open longer than necessary Check if the lid closes well and the gaskets are undamaged and clean Wait some hours and then check the temperature again Allow food to cool to room temperature before storing The compressor op- The temperature is not set correctly. Erates continually The lid has been opened too frequently The lid is not closed properly Large quantities of food to be frozen were put in at the same time Food placed in the appliance was too warm The temperature of the Try to reduce the temperaroom that contains the ap- ture in the room where the pliance is too high for effi- appliance stands cient operation Audible alarm and flashing alarm symbol It is too warm inside the freezer Refer to "Excessive Temperature Alarm" in "Control Panel" chapter Clean the lid gaskets Arrange the packages in the right way, see the sticker in the appliance Clean the lid gaskets Check the valve Close and open the lid. Refer to "Replacing the lamp" Set a lower temperature Check if the lid closes well and the gasket is undamaged and clean Try not to open the lid too frequently Do not leave the lid open longer than necessary The lid doesn't close The lid gaskets are dirty or completely sticky Food packages are blocking the lid The lid is difficult to open The lamp does not work The lid gaskets are dirty or sticky The valve is blocked The lamp is in stand-by. [. . . ]