User manual DOMETIC DS 400 REV 2004-06-24

[. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible content loss. The back of the product should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. Before defrosting, cleaning or maintenance work is carried out, be sure to switch off the appliance and unplug it. Under no circumstances should solid ice be forced off the cooling fins. [. . . ] NEVER USE STRONG CHEMICALS OR ABRASIVE CLEANING MATERIALS ON ANY PART OF THE CABINET. the rear cover) into the surrounding air. The more ventilated the condenser is, the more effective the refrigeration will be. The other condition for satisfactory operation is that the appliance stands on a flat surface. This is best seen by placing a glass of water on top of the appliance. It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an oven, etc. ). Built-in version When first using this refrigerator please consider the following points: ENSURE REFRIGERATOR IS LEVEL THE PIPEWORK AT THE BACK GETS HOT IN USE THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE VIRTUALLY SILENT ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING During the refrigeration process, the appliance gives off heat from the condenser (under the upper part of All four sizes of the miniCool family are available in builtin and freestanding version. Built-in under model does not have foot frame, cooling unit room cover, compared to the freestanding version. The miniCool can be screwed to the furniture using the fittings at the bottom. Drive in the screws (figure 3). 5 GB C Air out D miniCool min. 60 mm Ventilation grille Air out miniCool Air in Air in Figure 3. 4. 1. 2. Cooling unit room cover protects from the hot parts of the cooling unit. Foot frame with grilles ensures sufficient ventilation. During installation, please ensure the mains plug is accessible at all times. Figure 5. 5. Using the appliance IMPORTANT Please follow the installation details below carefully Guarantee is valid for products installed as described only. Ventilation must be provided as shown in alternatives A, B, C or D (fig 4-5) 4. Air passing through the duct must not be preheated by any source of heat 6. Ventilation grills, if used, must have openings of at least 200cm2 each To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 1-2 hours depending on ambiant temperature. 5. 1. Temperature regulation The device must be plugged into a properly earthed socket. The LED illuminates after plugging-in several times and after that continuous light can be seen if the door is open. The miniCool achieves its operating temperature after several hours. A B Air out The usual setting required is in the region of the middle of the thermostat knob (Fig. If it is found necessary to alter the setting, the knob can be turned to a higher symbol to produce a colder temperature, or a lower symbol to produce a warmer temperature. [. . . ] The wire coloured brown must be connected to the terminal marked L or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 14. Environmental protection information The appliance does not contain any CFCs/HCFCs. Ammonia (natural hydrogen and nitrogen compound) is used as a refrigerating agent in the refrigeration unit. [. . . ]