User manual DIGITECH VHM5

[. . . ] Double-click the installer and follow the on-screen instructions to install the driver for your device. aTTEnTIon: If your product requires a firmware update, backup your presets at this time using X-Edit before running the NetUpdater application. D UPDaTE yoUR fIRMWaRE USInG nETUPDaTER Using the NetUpdater application requires that you be connected to the internet. Turn on your device and connect it to an available USB port on your computer with a USB cable. 2. [. . . ] Double-click the netUpdater application icon on your desktop to start the application. When your device is listed in the found Devices screen, click next>. On the Version filtering screen, leave the default check box "only show the latest version. . . " selected and click next>. If there are updates available for your device, they will be displayed in the Select new version menu. On the next screen you will be asked to confirm and start the update procedure. aTTEnTIon: Updating your product will erase all user presets permanently. If you wish to keep your presets, please use X-Edit to backup your presets before proceeding. Place a tick in the check box and Click next> to start the update procedure. Once the update is complete, your device will perform a factory reset. Under MIDI Music Playback>Default device, open the pull-down menu and make sure Microsoft GS Wavetable Synth is selected as the default device (XP only). B. After the RPxxx is connected to your computer and powered on, open Cubase LE 4, and go to Devices>Device Setup as shown below. 2 2. Under Devices, click on VST audio System and select RPxxx aSIo from the ASIO Driver pull-down menu if it is not already selected. . Click on Switch to switch the driver and click oK. You are now ready to begin recording using your RPxxx and Cubase LE 4. B. After your RPxxx is connected to your computer and powered on, open Cubase LE 4, and go to Devices>Device Setup as shown below. 2. Click VST audio System and select DigiTech RPxxx In/out (2) as the ASIO Driver (as shown below). DO NOT select DigiTech RPxxx In/Out (1). . Cubase® LE 4 will now ask you if you would like to switch the driver. Select Switch then oK. Mac PPC users: After selecting RPxxx In/Out (2) in the Device Setup panel, you may need to verify that your device inputs are active. The box under the audio Device column may say "not Connected. " If it does, click in this box and select DigiTech RPxxx In/out (2) to enable the device inputs. You are now ready to start recording with Cubase LE 4. 4 2. Select a location to store the project (or use the default location) and click oK. (XP users only) If you ever see the warning message shown below when opening a new or existing project, you must reset the driver in the Device Setup dialog. [. . . ] Select a location to store the project (or use the default location) and click oK. (XP users only) If you ever see the warning message shown below when opening a new or existing project, you must reset the driver in the Device Setup dialog. To reset the driver, click Devices > Device Setup, and click the Reset button. B. When the Add Audio Track dialog appears, make sure the Configuration is set to Stereo and click OK. 2. [. . . ]