User manual DENON DP-30L(S)

[. . . ] Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. Do not insert anything inside Please, record and retain the Model name and serial number of your set shown on the rating label. [. . . ] Adjust so that the head shell and the cartridge are in parallel and in right angle (Fig. Securely fix the screws after positioning the cartridge in the dimension shown in Fig. At this position, a specified overhang can be obtained when mounted on the tonearm. 2 Attaching counterweight Note: When the cartridge is replaced, its weight will be different and so will be the stylus force. Be sure to adjust the stylus force, anti-skating and the aim lifter height. It is easier if you replace cartridges readily mounted on a head shell than to replace cartridge alone. Therefore it is recommended to obtained a head shell together when you purchase another cartridge. The combined weight of 14g to 19g of the head shell and accessories is acceptable. (1) (2) (3) Attaching and detaching head shell on/from tonearm As shown in Fig. For removing the head shell, turn the lock nut in the opposite direction of the arrow and gently pull it off. Mounting dust cover Hold the dust cover near the hinges by both hands as shown in Fig. 7 and push the "metal parts" of the hinges deep enough unto the "hinge catchers" of the cabinet. For removing the dust cover, open it fully and pull it off in the same mariner. Connect the L and R pin plugs of output cord to the L and R "phono" inputs of the amplifier to be used. 8) Also connect the Y-shaped lug of ground wire (combined with the output cord) to the "GND" terminal of the amplifier. Note: Some cartridges may require a step-up transformer or a head amplifier depending on their type. (Or else, if AC outlet is provided on your amplifier connect the power supply cord thereto, referning to Fig. Make sure at this time that the power capacity of the outlet is sufficient. Adjustment of stylus force Set to the optimum stylus force for your cartridge as follows. If it is used with improper stylus force, mistracking or distorted sound may result. (1) (2) (3) (4) (5) (6) (7) (8) (9) Turn the power switch ON ( ). Turn the anti-skating knob and set "0" to the reference line as in Fig. [. . . ] 7 mm) mounting center WEIGHT: 6 grams TERMINALS : 4 terminals CONNECTIONS: 4-Lead Stereo Connection: Connect "hot" lead of right channel to terminal "R" (usually red) and shield or ground lead of right channel to terminal "RG" (usually green). Connect "hot" lead of left channel to terminal "L" (usually white) and shield or ground lead of left channel to "LG" (usually blue). To prevent "ground loops" and hum, no common connection should be used at cartridge terminals. Make all solder connections to terminal jacks provided before slipping them over the terminals. [. . . ]