User manual DENON DCD-2020AE GETTING STARTED

[. . . ] Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When disconnecting the power supply cord from the wall outlet, hold the plug and do not pull on the cord. Do not open the top cover In order to prevent electric shock, do not open the top cover. [. . . ] The DCD-2020AE can be controlled from a distance using the included remote control unit (RC-997). Replace the batteries with new ones approximately once a year, though this depends on the frequency with which the remote control unit is used. If the remote control unit does not operate from close to the main unit, replace the batteries with new ones, even if less than a year has passed. When inserting the batteries, be careful to do so in the proper direction, following the < and > marks in the remote control unit's battery compartment. Do not short-circuit, disassemble, heat or dispose of batteries in flames. Remove the batteries when not planning to use the remote control unit for a long period of time. If the batteries should leak, carefully wipe off the fluid from the inside of the battery compartment, then insert new batteries. When operating the remote control unit, point it at the remote control sensor as shown in the figure. The remote control unit can be used from a direct distance of approximately 8 meters. This distance will be shorter, however, if there are obstacles in the way or if the remote control unit is not pointed directly at the remote control sensor. The remote control unit can be operated at a horizontal angle of up to 30° with respect to the remote control sensor. Pick up the disc carefully so as not to touch the signal surface and hold it with the labeled side facing up. If the layer is switched while the disc is being loaded, the playback layer switches for that disc, but the top priority playback layer setting itself does not change. When a disc is loaded after the setting has been made, the contents recorded on the set layer are displayed. If a disc that does not contain the layer set for top priority playback is loaded, the contents recorded on another layer are displayed automatically. This setting is stored in the memory and is not cleared even when the disc holder is opened or closed or the power is turned off. Various playback functions Playing a specific track (Remote control unit only) [Direct play] Use the number buttons and the +10 button to select the desired track. : To select track 4 : 4 To select track 12 : +10 , 2 To select track 30 : +10 , +10 , +10 , 0 Playback starts from the selected track. Stopping playback temporarily [Pause] For Super Audio CDs, use the SUPER AUDIO CD SETUP button to set the layer to be played, as necessary. Press the button again while one of these is displayed to switch the layer to be played. Use this function to stop playback temporarily, and later resume playback from that point. To resume playback from the position at which the disc is paused, press the 1/ 3 button (the 1 button, or the 3 button on the remote control unit). [. . . ] When the TITLE or ARTIST button is pressed, the text scrolls once, then only the first 13 characters of the text are displayed. When the track is switched while the track title is being displayed, the title of the new track is scrolled. "NO TEXT" is displayed if the TITLE or ARTIST button is pressed when a disc that does not contain text information is loaded. The all-track repeat mode can also be set by pressing the REPEAT button during playback. [. . . ]