User manual DENON AVR-1313

[. . . ] Do not let insecticides, benzene, and thinner come in contact with the set. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. No naked flame sources, such as lighted candles, should be placed on the apparatus. No objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] This is due to the built-in muting circuit that prevents noise when the power switch is turned on and off. Set the power operation switch to this position to turn the power on and off from the included remote control unit. In this position, the power cannot be turned on and off from the remote control unit. The front speaker A, B setting can be also be changed with the SPEAKER button on the remote control unit. Notes on playing a source encoded with DTS · Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. In some rare cases the noise may be generated when you preform the operation to stop playback of a DTS-CD or DTS-LD. To select the surround mode while adjusting the surround parameters, channel volume or tone control, press the surround mode button then operate the selector. With the name of the volume to be adjusted selected, turn the SELECT knob to adjust the level. If you do not want the bass and treble to be adjusted, turn on the tone defeat mode. The signals do not pass through the bass and treble adjustment circuits, providing higher quality sound. [2] Listening over headphones The DIGITAL indicator lights when digital signals are being input properly. The adjusted playback levels for the different surround modes are automatically stored in the memory of each surround modes. After adjusting using the test tones, adjust the channel levels either according to the playback sources or to suit your tastes, as (described) below. The level of the selected speaker can be adjusted within the range of +12 to ­12 dB. Only adjustable when the channel is selected with the CH VOL buttons on the main unit. The Dolby Surround Pro Logic II Cinema or Music mode can be chosen directly by pressing the CINEMA or MUSIC button on the remote control unit during playback in the Dolby Surround Pro Logic II mode. Select the function to which the component you want to play is connected. Surround parameters q Pro Logic II Mode: The Cinema mode is for use with stereo television shows and all programs encoded in Dolby Surround. Panorama Control: This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side wall imaging. Dimension Control: This control gradually adjust the soundfield either towards the front or towards the rear. Center Width Control: This control adjust the center image so it may be heard only from the center speaker; only from the left/right speakers as a phantom image; or from all three front speakers to varying degrees. Dolby Digital mode (only with digital input) and DTS Surround (only with digital input) To perform this operation from the remote control unit, check that the mode selector switch is set to "AUDIO". [. . . ] They do not include picture data, but they offer surround playback on CD players that are equipped with digital outputs (PCM type digital output required). DTS surround track playback offers the same intricate, grand sound as in a movie theater, right in your own listening room. Have you operated the receiver according to the Operating Instructions ?If this unit is not operating properly, check the items listed in the table below. [. . . ]