User manual DELONGHI HMP 1500

[. . . ] Never locate heater where it may fall into a bath tub or other water container. Arrange cord away from traffic area and where it will not be tripped over. To disconnect heater, turn controls to off, then remove plug from outlet. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the heater. [. . . ] Check that neither the heater nor the power cable has been damaged during transport. Your heater is suitable for either freestanding or wall mounting usage. Electrical connection - Before plugging in the appliance, check that your supply voltage is the same as that shown on the rating plate of the Appliance and that the power supply is able to with stand the power consumption (Watts) shown on the rating plate. - If using more than one appliance at a time, it is important to ensure that the power supply is able to with stand the Free standing operation To fit the feet to the appliance, proceed as follows: Fix the foot with the supplied screws, as shown in fig. ASSEMBLY KIT The wall mounting kit contains: 4 x screws for wall mounting 4 x anchors (0. Wall-Mounting Installation Before installing the unit , make sure of the following: a. The power outlet can be easily reached by the plug and after installation. No electric cables or other pipes could be damaged during the installation. to wall-mount , proceed as follows: For brick walls use a 15/64" (6 mm) concrete drill bit . For plaster board or false (hollow) walls, it is recommended to use appropriate screws and anchors (not supplied). Before drilling the wall, mark out a template using the mounting bracket respecting the minimum distances as Drill the wall where previously marked, and insert the plastic anchors. Remove the appliance, drill the lower holes and insert the wall anchors. Now, you can hang back the heater to the bracket and fix the lower part of the appliance with the 2 remaining Functioning and use - Insert the plug into the mains. - Turn the thermostat knob in a clockwise direction until it reaches the 6 setting. - Minimum power (750W): turn the function knob to setting "MIN" (the pilot light will light on). - Maximum power(1500W): turn the function knob to setting "MAX" (the pilot light will light on). - Switching off: turn the function knob to setting"OFF" and remove the plug. Adjusting the thermostat Turn the thermostat knob in a clockwise direction until it reaches the maximum setting (6). When the room has reached the desired temperature, slowly turn the thermostat knob counter-clockwise until you hear a click and not beyond. The thermostat will now adjust the set temperature automatically keeping it constant. Frost prevention mode With the thermostat dial at minimum and the mode selector on "MAX", the appliance maintains room temperature at about 41° F (5°C), preventing freezing with minimal energy consumption. Maintenance Before carrying out any maintenance, unplug the heater from the mains and wait for it to cool off completely. [. . . ] If repairs become necessary, see contact information below: Residents: Please contact our toll free hotline at 1-800-322-3848 or log onto our website at www. Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto our website at www. Residents of Mexico: Please contact our toll free number 01-800-711-8805 for assistance or log onto our website at www. The above warranty is in lieu of all other express warranties and representations. [. . . ]