User manual DELONGHI EV250.BK

[. . . ] This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. Always unplug the appliance before refilling the water tank, cleaning, servicing or relocating the unit. Do not pull on or place strain on the power cord when moving the appliance. [. . . ] 5) and the air, flowing through the cooling pad, comes out fresh and contributes to decrease the room temperature; Put the ice box/pack vertically in the front left corner of the tank as shown in figure 8; Replace the water tank, turn on the appliance and select Cooling/Humidifying: the air flow will be fresher than before (fig. Please note: Always check the Ice box/pack is correctly inserted in its housing (see fig. Please note: At first use, the appliance could emit a strange odor and the water could be discolored: this is part of normal use. Using the ice box/pack you can increase the efficiency of the appliance. 3 Selecting the fan mode The appliance can be set for 3 different fan modes: 1. NORMAL- Press the button (B2 or D4) to select the The You can also adjust vertically the vent by lightly pushing the vent Appliance performs random ventilation cycles at different to orientate the air flow (fig. 13): always adjust the vent when Pliance runs 30 minutes at MAX speed, then 30 minutes at MED speed: then runs continuosly at MIN speed (fig. You can set the delayed shut off from 1 to 24 hours by pressing Select the number relative to the operating hours desired: The number will be shown on the display (C1); Ming the auto off: when the flashing stops, the auto off is Press the button (B5 or D2)once to activate the rotating The corresponding LED turns on and off accordingly. If you want to exit the "Auto off" function, repeatedly press the button (B6 or D3) until "00" is displayed: symbol fla- REFILLING THE WATER TANK Please note: Turn off the unit and let sit two minutes before removing drawer to allow excess water to drain back into tank. Always check that there is water in the water tank before using the Cooler/Humidifying function. If the water finishes in the tank during use, the appliance emits a beep and the symbol flashes (fig. 1 Cleaning the dust filter and the cooling pad To avoid clogging of the dustproof filter, please clean the filter regulary. The frequency of cleaning is to be related to the working time: if used daily, it is suggested to clean filter weekly. Remove the dust from the filter and the cooling pad using a 5L (152oz) of fresh tap water only (do not overfill the water tank: see water level indicator A2); 2. Wash thoroughly the cooling pad with water; then leave it to completely dry and reassemble the filters in its housing (fig. Do not spray insecticide liquid or similar since the plastic Clean the surface of the unit with a damp cloth, never use an abrasive scourer directly on the outside surface as it might scratch. To maintain the efficiency of the appliance, it is suggested to change the cooling pad every year. 2 Cleaning the water tank Please note: Turn off unit and let sit two minutes before removing drawer to allow excess water to drain back into tank Clean thoroughly with a cleaning sanitizer, easily available 3 Changing the battery of the remote control · Remove the battery holder on the back of the remote con- Insert one 3V CR2025 type lithium battery on the support, checking that the polarity is correct (+ and -) (fig. If you change or dispose the remote control, the bat- Tery must be removed and disposed of according to local recycling regulations. Never throw the battery in fire as it may explode or leak dangerous liquids. [. . . ] In very Check the Honeycomb Cooling Pad (A12), water Damp conditions, algae may form due to tank (A7) and other cooler parts. Away the algae until all spots have disappea- Make sure all parts are clean and dry before Algae or mold, change it with a new one Lowing the polarity guide inside the battery Remote control battery is exhausted Replace with a new battery If replacing new battery in the correct position does not work, contact Customer Service The unit does not respond Try to activate the unit with the remote control If the unit responds, then the control panel on the unit may be experiencing problems: contact Customer Service If neither the remote control or the control panel is working, contact Custoner Service If "Cooler/Humidifier" indicator Because of no water in the tank flashes and unit beeps Fill tank above MIN mark with water Store the unit with water tank empty. This product complies with the maximum allowable concentration of ozone of 0. Insérer une pile de type 3V CR2025 dans le support en fai- TROUBLESHOOTING Below is a list of some of the possible malfunctions. [. . . ]