User manual DELONGHI BCO 65

[. . . ] · The power supply cable of this appliance must never be replaced by the user, because its replacement requires the use of special tools. If the cable should become damaged, or in case it needs to be replaced, please go to a Service Centre authorized by the manufacturer. · Disconnect the plug from the electrical outlet and turn off the ON/OFF switch when the appliance is not in use. Do not leave the appliance uselessly plugged in. DESCRIPTION OF THE APPLIANCE The following terms are used throughout the instructions manual. [. . . ] · Close the filter holder and place the pot, with its lid inserted, onto the hot plate. HOW TO SELECT THE AROMA OF THE FILTER COFFEE With the Flavour System , it is possible to select the aroma of the filter coffee depending on personal taste. 9), the coffee machine can be programmed for a strong flavour (STRONG position) or a lighter flavour (LIGHT position). The Flavour System feature changes the flavour of the coffee, more or less strong, while the true taste of the coffee remains unchanged. HOW TO PREPARE ESPRESSO COFFEE 1. Unscrew the plug of the hot water heater tank by turning it in a counter-clockwise direction. Using the level indications stamped on the WATER LEVEL side, fill the small pot with the amount of water suggested (fig. 10) according to the number of cups of espresso coffee that are desired (see the chart at the end of this text). Replace the plug in the hot water heater tank by turning firmly in a clockwise direction. Fill the filter with the ground coffee, respecting the dosages indicated in the chart at the end of this text and distribute it uniformly in the filter (fig. It is important to use the highest quality coffee and having a medium grind in order to avoid the obstruction of the filter during the brewing. To attach the filter holder to the appliance, position it under the hot water drip spout with the handle towards the left, see fig. Push upwards, and at the same time, turn the handle towards the right. Place the coffee pot for espresso coffee under the filter holder so that the spout where the coffee exits the filter is inside of the opening found on the lid of the coffee pot (fig. Position the "Vario System" selector according the type of espresso coffee desired: "LIGHT" for a lighter coffee and "STRONG" for a stronger tasting brew (fig. After approximately two minutes, the espresso coffee will begin to flow out (fig. ATTENTION: to avoid spraying, never detach the filter holder while the machine in brewing coffee. When the coffee no longer flows out from the filter holder, push the ON/OFF switch for espresso/cappuccino to turn off the hot water heater (fig. Before removing the filter holder, it is important to eliminate all of the residual steam from the inside of the hot water heater to avoid puffs of steam. Allow it to blow out completely by rotating the steam release knob (fig. To dispose of used grounds in the filter, first remove the filter holder by turning the handle to the left. Using the special lever in the handle to keep the filter in place, remove the grounds by turning the filter holder upside down and srtikinggently. 21). 8 NOTE: For safety reasons, when the hot water heater is hot, it is not possible to remove its plug as it will spin without opening. If for any reason it is necessary to remove it, it is important to always release the steam in the hot water tank by acting on the steam release knob as described in the previous point. HOW TO USE THE TWO CUP ATTACHMENT The attachment allow espresse coffee to drip directly into the cups at the same time. [. . . ] · In order to make 4 cappuccinos, it is necessary to repeat the previous operations, paying attention to the quantity of ground coffee and water, indicated in the chart at the end of the text. Furthermore, before positioning the Vario System selector to the Cappuccino position, brew enough coffee into the coffee pot to reach the level 4 on the "COFFEE LEVEL" side as indicated in figure 24. IMPORTANT: The milk frother for cappuccinos must be thoroughly cleaned after each use. · When the all of the solution has gone through the machine, turn off the appliance and let it cool down. [. . . ]