User manual DAEWOO DWM-500M

[. . . ] , , , , , , CAUTIONS s Be sure that washer is grounded. To avoid electrical shock, use a metal pipe for the ground connection. But, do not ground the washer with gas pipes or telephone lines to avoid dangers of explosion or lightning strike. s Disconnect the power cord from the power supply when not in use. s Ventilation openings must not be obstructed by carpeting when the washing machine is installed on a carpeted floor. s Do not put your hands into the spin dryer basket when it is spinning. Your fingers can be caught by spinning laundry and damaged. s If the supply cord of this appliance is damaged, it should be replaced by a repair shop appointed by manufacturer, because special purpose tools are required. s Never allow children to operate or play with the washer. Children playing with the washer may accidentally fall into the washing tub. s Turn off the SPIN Timer immediately when the spin dryer makes noise and vibration excessively during spinning. PRECAUTIONS WHEN OPERATING s Don't use excessively hot water. [. . . ] Select "OFF" to stop spinning. @ WASH SELECTOR Select "WASH · RINSE" for washing and rinsing, Select "DRAIN" to drain the water. Select "OFF" to stop washing, rinsing and draining. WA SH ! 15 0 3 @ IN -R SE OFF # DRAIN OFF S PIN 12 6 TIMER 9 WASH SELECTOR SPIN SELECTOR 2 , , WASHING PROCEDURE ¡Æ WASH TO !(In case of NO DRAIN PUMP model) Place the drain hose in sink or bath. (In case of DRAIN PUMP model) Connect the power cord to the power supply outlet. # Fill water in the wash tub to the desired water level and add detergent. ^ After washing, set the WASH SELECTOR to "DRAIN" for drain and set the TIMER to the proper time. ¡Æ SPIN DRY TO !@ Supply the proper amount of water as not to overflow the top of the washing tub. $ To drain the water, set the WASH SELECTOR to "DRAIN" and set the TIMER to the proper time. (Adjust water pressure to ensure that the amount of supplied does not exceed the amount of drain. ) # Set the TIMER 6~8 minutes. $ As soon as the TIMER shuts off or the rinsing water become clear, turn off the water tap. % To drain the water, set the WASH SELECTOR to "DRAIN" and set the TIMER to the proper time. 3 , , , , INSTALLATION s LOCATION & ENVIRONMENT Leave some space. If the washer is placed on an uneven or weak surface, noise or vibration may be occurred. [. . . ] (In case DRAIN PUMP model) (NO DRAIN PUMP) Less than 10cm (PUMP) 85Cm s LEG SETTING Slide the leg into the opening underneath the base, and push. CLEANING & MAINTENANCE Proper care of your washer can extend its life. s CLEANING THE OVERFLOW FILTER Insert your finger into hole "A" and then pull the overflow filter in the direction of arrow as shown in the figure. A s CLEANING THE DRAIN FILTER In case of incomplete drain, remove lints from the drain filter with soft brush. s CLEANING THE WASHER BODY Wipe of stains on the cabinet and control panel with soft cloth. (Plastic parts will be damaged. ) s CLEANING THE WASH TUB Fill water in the wash tub to "L" level, and operating wash cycle for 1~2 minutes. [. . . ]