User manual DAEWOO DW-444PA

[. . . ] In case of 2 conductor power cord: Connect the grounding wire to a water faucet etc. Make sure that the power cord is unplugged during ground work. Connection of Hoses Attach the drain hose to the drain outlet at the left side of the under base and secure with the clamp provided. Hang the "U" Shaped outlet of the drain hose on the edge of a sink. Attach the water inlet hose to the water inlet located at the left-hand side of the control panel. [. . . ] Set the selector switch to the position recommended in the Washing Guide. DRAIN HOSE SETTING (1) Connect the drain hose to the drain outlet at the rear side of your washer, and then fasten it tightly with the hose clamp. (2) The other end of the drain hose should be set toward the bath or sinkhole. (In case of drain pump model) Drain Outlet A Drain hose Hose Clamp OPERATING INSTRUCTIONS Set the wash timer to the wash period recommended in the Washing Guide. When the wash period expires, set the drain selector to the drain position to discharge the water. Note: Before rinsing, the wash load may be transferred to the spin bowl to spin dry for 1 minute (approx. ) to remove excess suds (see Spin Drying). On completion, transfer the wash load to the wash tub for rinsing. 2 DW-444PA 00. 4. 26 11:8 AM `3 To Rinse in the Wash Tub Set the drain selector to the "wash-rinse" position. Open the water tap and fill the tub to a suitable water level for the laundry. Repeat proceses 1 to 4 twice or three time according to the condition of the washed laundry. Spin Drying To open the inner safety lid of the spin bowl, lift up the outer lid, then pull the catch forward and lift upward. Transfer either the full wash load or portion to the spin bowl commencing with small articles. Place the removable spin mat over the load to be dried and push lightly downward. (To contain delicated articles within the spin bowl. ) Close the inner safety lid, then the outer lid. The spin bowl will spin for the time selected, then stop (at position "0"). Caution: Ensure that the spin bowl completely stops before opening the inner lid. If there is any abnormal vibration during spining, open the lids to stop the spin-tub and rearrange the clothes to be in good balance. If the drainage from the wash-tub and spin-tub occurs simultaneously, the drainage from spin-tub will be obstructed and there may be a malfunction. Therefore, if you need to drain the wash-tub while spinning, be sure to drain the wash-tub after at least one minute's spinning. Note: The pump motor will operate when the spin dry timer is set, irrespective of whether the outer lid is closed or opened. OPERATING INSTRUCTIONS Simultaneous Washing and Spin Drying Three motors ate fitted to cover washing, spin drying and drainage. This arrangement enables spin drying of a previous wash load and washing of a new wash load to be simultaneously effected. To do this, set the controls for both "wash" and "spin" modes (see "to wash" and "spin drying"). Washing Guide Size of Wash Load Full Half & Less Full Half & Less Half & Less Degree of Soiling Heavy Normal Light Normal Light Wash Selection Switch Heavy Normal 5-10 mins. Water Temperature Wash Cycle Type of Fabric Fast Coloured Cotton and Linens Nylon and P. P Water Level High Medium Wash Period Spin Period High Medium or Low High Normal Soft 4-5 mins. 2-3 mins. 2 mins. Delicates Normal to Light Soft 2-3 mins. 1-2 min. . 3 DW-444PA 00. 4. 26 11:8 AM `4 Control Panel Drain Selector (Pump control) Water Inlet Wash Timer Wash Selector Spin Timer OPERATING INSTRUCTIONS Emptying Set the valve selector knob to "drain" and the wash timer to 3-5 minutes. Switch off the electricity at the power point. Lint Filter Remove the filter frame by pulling it upward (Fig. [. . . ] The spin dry timer is set. If there is excessive noise, check whether: Something is touching the agitator as it rotates. The wash load in the spin bowl is excessively unbalanced during the spin cycle. An article is lodged between the spin bowl and tub. MAINTENANCE AFTER USE Wash Day Maintenance At the end of each wash day: Switch off the electricity at the power point. Wipe off spillage from wash powder, etc. , and generally wipe over the cabinet with a clean damp cloth. [. . . ]