User manual DAEWOO DSB-181L

[. . . ] OWNER'S MANUAL SPLIT AIRCONDITIONING SYSTEM MODEL #: DSB-181L/181LH S1 SAFETY INSTRUCTIONS PLEASE READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE INSTALLING AND OPERATING THE UNIT: This air conditioner meets strict safety and operating standards. The installer of this unit must install or service this unit so it operates safely and efficiently. Precautions When Wiring: · Do not plug in the unit until all connections (tubing, drain hose, mounting, etc. ) have been made and double-checked. · High voltages are present in this unit and are very dangerous. Improper connections or inadequate grounding can cause accidental injury. [. . . ] All you have to set is the desired temperature and it will control the fan, coolness and dehumidifier. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. The desired temperature can be changed up or down 1 degree from the actual room temperature. Then the unit will automatically operate. AUTO 10 TO SET QUICK MODE To set this unit to cool or heat at the highest power, follow the procedures below: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. The unit will then start cooling or heating the room at the highest power. TO SET COOL MODE To set the unit to cool the room to a desired temperature, follow the procedures below: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Press the MODE button until the Cool indicator appears in the display. 3. The desired temperature can be changed up to 32°C and down to 18°C. 4. To select the fan speed, press the FAN SPEED button until the desired speed appears in the display (see below). FAN SPEEDS AUTO "AUTO" "" "" "" "NATURAL" The fan will automatically select the fan speed. The fan will randomly cycle through the speeds simulating a cool breeze. 11 TO SET FAN ONLY MODE To operate only the fan so the unit will circulate the air, proceed as follows: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. To select a fan speed, press the FAN SPEED button until the desired speed appears in the display (see below). FAN SPEEDS "" "" "" "NATURAL" The fan will operate on low speed. The fan will randomly cycle through the speeds simulating a breeze. NOTE: · If "NATURAL" is selected, the NATURAL" indicator on the indoor unit will light. TO SET DEHUMIDIFIER MODE Select this mode when there is high humidity. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Press the MODE button until the Dehumidifier indicator appears in the display. 3. The desired temperature can be changed up to 32°C and down to 18°C. 12 TO SET UNIT TO HEAT MODE (DSB-181LH ONLY) To set the unit to heat the room to a desired temperature, follow the procedures below: 1. Press the ON/OFF button on the remote control to turn the unit on; the On LED will light on the indoor unit and "ON" will light in the remote display. Press the MODE button until the Heat indicator appears in the display. In the heat mode, the fan direction (UP, DOWN) is further downward than that in the cool mode for the good circulation. To select the fan speed, press the FAN SPEED button until the desired speed appears in the display (see below). 3. The desired temperature can be changed up to 32°C and down to 18°C. NOTE: When the heating orperation is started, hot air delivery might be delayed due to warm up period. FAN SPEEDS The fan will automatically select the fan speed. [. . . ] Insert cleaned or new small filters (Deodorizing and Electrostatic) back into the unit. 5. Insert cleaned or new black filters back into the unit. CLEANING THE INDOOR COVER To clean the indoor cover, follow the procedures below: 1. Remove the left and right side to open the indoor cover upward by two hands. (Remove it when cleaning. ) NOTES: · Wipe the indoor cover with soft sponge or soft cloth. [. . . ]