User manual DA-LITE VIDEO PROJECTOR INTERFACE
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual DA-LITE VIDEO PROJECTOR INTERFACE. We hope that this DA-LITE VIDEO PROJECTOR INTERFACE user guide will be useful to you.
Manual abstract: user guide DA-LITE VIDEO PROJECTOR INTERFACE
Detailed instructions for use are in the User's Guide.
[. . . ] The POWER In PRESENTATION PRODUCTS
Installation Instructions for
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www. da-lite. com e-mail: info@da-lite. com
VIDEO PROJECTOR INTERFACE
VIDEO PROJECTOR INTERFACE INSTALLATION
The Video Projector Interface (VPI) housing is divided into three compartments. [. . . ] When extending the low voltage connection from the projector's screen trigger output, be sure to maintain the proper polarity. the red wire from the VPI is the "signal" and the black wire from the VPI is the "ground". Connect the wires from the VPI that are labeled "Low Voltage Connection" to the end of the extended screen trigger wires above.
CAUTION: NEVER APPLY VOLTAGE TO THE PROJECTOR'S SCREEN TRIGGER WIRES OR THE VPI AND/OR PROJECTOR WILL BE DAMAGED.
120V
240V
RED BLACK
RED BLACK
RECOMMENDED WIRE SIZE: 20-24 AWG
5/12 VOLT SCREEN TRIGGER ON PROJECTOR
RECOMMENDED WIRE SIZE: 20-24 AWG
5/12 VOLT SCREEN TRIGGER ON PROJECTOR
FIGURE 1
1
AC POWER CONNECTIONS
Screen Motor 1. Using 4-conductor, 14-18 gauge wire, extend the motor wires from the screen junction box to the length required to reach the VPI. Connect the extended wires from the screen motor to the VPI wires that are labeled "motor wires". Refer to Figure 2.
120V
240V
SCREEN MOTOR GREEN WHITE BLACK GROUND LUG GREEN/YELLOW BLUE BROWN
SCREEN MOTOR GROUND LUG
RED
BLACK
RECOMMENDED WIRE SIZE: 14-18 AWG
RECOMMENDED WIRE SIZE: 14-18 AWG
FIGURE 2
AC Power Source 1. Connect the incoming power wires to the VPI wires that are labeled "AC power input". [. . . ] Refer to Figure 4.
120V
240V
RED BLACK WHITE BACK OF WALL SWITCH
FRONT OF WALL SWITCH
UP STOP
RED BLACK WHITE BACK OF WALL SWITCH
FRONT OF WALL SWITCH
UP STOP
DOWN
DOWN
NOTE: 20-24 AWG WIRE RECOMMENDED FOR CONNECTING WALL SWITCH TO VPI CONTROLLER
NOTE: 20-24 AWG WIRE RECOMMENDED FOR CONNECTING WALL SWITCH TO VPI CONTROLLER
FIGURE 4
Printed in U. S. A.
3
93841 Rev. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DA-LITE VIDEO PROJECTOR INTERFACE
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual DA-LITE VIDEO PROJECTOR INTERFACE will begin.