User manual DA-LITE SCENIC ROLLER PROJECTION SCREEN

[. . . ] Instruction Book For Scenic Roller Projection Screen The POWER In PRESENTATION PRODUCTS DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574/267-8101 800-622-3737 Fax: 574/267-7804 http:// www. da-lite. com e-mail: info@da-lite. com PRE-INSTALLATION 1. [. . . ] Drop the closed loop of the turnbuckle in the slot of the center clamp before inserting bolt. Pulleys at each end of header must be in the vertical position, when hung for proper operation. 5 Adjust top header in fabric pocket to the 2-1/4" and 3-3/4" position shown on the drawing. When this screen is shipped from the factory, there are 2-1/2 turns of rope around each end of the roller. Before Dropping fabric make certain ropes at end of bottom roller do not overlap. Overlapping of ropes will cause rope to work inward and thus damage the fabric. CLAMP ASSEMBLY ILLUSTRATION B SCREEN ADJUSTMENT 1. With screen in the "Down" position, turn the header in the fabric pocket carefully to adjust the pulleys to a vertical end position. With unit in completely unrolled position, examine the screen carefully. [. . . ] Caution stage hands and others to avoid bumping screen with ladders, scenery, etc. 1 TURNBUCKLE - ADJUST FOR FLAT FABRIC HANG LOCATE CLAMPS ON REINFORCEMENT TAPE 6" 3 /4" 3 MOUNT AT THESE THREE POINTS ONLY 6" 2 /4" 1 MOUNT HEADER TUBE LEVEL DA-LITE SCENIC ADJUST ROPE CLAMP FOR PROPER FULL SCREEN OPENING PULLY MUST BE INSTALLED IN THE VERTICAL POSITION OF SCREEN 2 CHECK HERE FOR FOREIGN MATTER BEFORE RAISING SCREEN DO NOT HANDLE UNIT BY FABRIC AREA HANDLE UNIT ONLY BY TOP HEADER AND ROLLER ENDS DURING INSTALLATION Illustration A Printed in U. S. A. 3 45037 Rev. [. . . ]