User manual DA-LITE PM7UL-47JF

[. . . ] Insert Casters into caster sockets and stand cart upright on hard flat surface. The Mount may be tilted using the fasteners shown, however, secure Mount in the vertical position at this time. C 3 U Figure 5 8. Secure the Hanging Brackets to the back of the flat panel display utilizing all of the fastener points recommended by the flat panel manufacturer. [. . . ] Fasten the middle shelf to the legs with two screws and nuts per corner. Place the top shelf inside of the legs and fasten with two screws and nuts per corner. Insert Casters into caster sockets and stand cart upright on hard flat surface. Tighten all fasteners. 2 HOLE SIDE 11 8 11 6 F V W 5 6. The Mount may be tilted using the fasteners shown, however, secure Mount in the vertical position at this time. C 3 T Figure 5 8. Secure the Hanging Brackets to the back of the flat panel display utilizing all of the fastener points recommended by the flat panel manufacturer. See Figure 6. Note: It is the responsibility of the installer to obtain any additional fasteners needed to secure the hanging brackets to the flat panel unit. Figure 6 1 P R 9. Hang the flat panel display on the Mount making certain the top and bottom notches on each Hanging Bracket are placed over the upper and lower Zee-Bars. 8 ZEE-BAR Q Figure 7 TILT CONTROLLING 3/8" FASTENER 4 PLACES 10. Slide the Security Bar through the slots in the Hanging Brackets and Mount, bolt one end to the Zee Bar and then secure the opposite end with the padlock. Use extreme caution if you must adjust the height with the flat panel display in place. Tighten all fasteners. U 4 7 Figure 9 SAFETY GUIDELINES The PM8UL-44F will provide the safest transportation of flat panel monitors when the following guidelines are met. The PM8UL-44F is designed to handle a flat panel monitor weighing up to 80 pounds. Use with larger monitors may cause instability resulting in possible injury. PixMate Flat Panel Mount Cart PM10UL-44F Form E-469 Rev. MAXIMUM MONITOR WEIGHT OF 100 lbs. Caution: The user of this product should exercise caution when moving the PixMate Cart. [. . . ] See Figure 6. Note: It is the responsibility of the installer to obtain any additional fasteners needed to secure the hanging brackets to the flat panel unit. Figure 6 1 P R 9. Hang the flat panel display on the Mount making certain the top and bottom notches on each Hanging Bracket are placed over the upper and lower Zee-Bars. 8 ZEE-BAR Q Figure 7 TILT CONTROLLING 3/8" FASTENER 4 PLACES 10. [. . . ]