User manual DA-LITE MULTI CHANNEL INFRARED CONTROL

[. . . ] The POWER In PRESENTATION PRODUCTS Instruction Book for DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574/267-8101 800-622-3737 Fax: 574/267-7804 http:// www. da-lite. com e-mail: info@da-lite. com MULTI CHANNEL INFRARED CONTROL DESCRIPTION The Multi Channel Infrared Control (MCIR) provides low voltage control for the three masks of the Multi-Mask Imager screen. Each mask can be operated independently by three individual three-button low voltage switches or by a single infrared remote. INSTALLATION LOW VOLTAGE CONNECTIONS: WARNING: To prevent electrical shock or damage to the LVC, do not apply power to the LVC until all connections are complete. [. . . ] A momentary closure across the white and red wires will be an "up" command. A momentary closure across the white and black wires will be a "down" command. A momentary closure across the white, red and black wires will be a "stop" command. Never apply voltage to the wall switch lead or the MCIR will be damaged. !Connect the black and red motor wires in the screen junction box to the red and brown MCIR wires as shown in diagram 1. Use 14-18 gauge wires to extend the motor wires to the required length. If the MCIR is connected to a different model screen you will have to reverse the red and black motor wires or the up and down commands will be backwards. Connect power wires to the black and white MCIR wires as shown in diagram 1. Connect the building ground wire to the green ground wire as shown. 1 INSTALLATION AC POWER 115V 60HZ 4 AMP BLACK - HOT WHITE - COMMON GREEN - GROUND MOTOR 1 MOTOR 2 MOTOR 3 GREEN GREEN WHITE GREEN GREEN WHITE GREEN - GROUND WHITE - COMMON BLACK - HOT GREEN - GROUND WHITE - COMMON BLACK - HOT GREEN GREEN WHITE RED RED BLACK BLACK BLACK RED GREEN - GROUND WHITE - COMMON BLACK - HOT BROWN BROWN BROWN RED RED RED CONTROL 1 CONTROL 2 CONTROL 3 ADDRESS SELECTION SWITCH WHITE BLACK RED WHITE RED BLACK WHITE RED BLACK IR SIGNAL WIRE (PREINSTALLED) UP STOP DOWN IR SENSOR UP STOP DOWN UP STOP DOWN DIAGRAM 1 Infrared Control 1. Carefully remove the number one control from the junction box and connect the IR sensor to the onboard conector as shown in diagram 1. [. . . ] To use the transmitter, first press the number on the keypad that corresponds to control number that you want to activate. You can continue to operate that control until a different number is entered on the keypad. 2 Printed in U. S. A. 3 95288 8/04 [. . . ]