User manual DA-LITE ELECTRIC SCREEN STUDIO ELECTROL

[. . . ] ELECTRIC SCREEN STUDIO ELECTROL Instructions for installation and use IT IS IMPORTANT FOR EVERYONE'S SAFETY TO FOLLOW ALL THESE INSTRUCTIONS. [. . . ] · NOTE: Excessive continuous operation may cause the motor to overheat. If this happens the motor will shut off until it cools to a normal operating temperature. Designed for optimum functioning between 15°C and 25°C and maximum humidity of 80%. Must be kept away from sources of heat (as these may cause fabric deformation) and protected from splashes of water, steam, dust, smoke or any other hazards that may damage the equipment . This class of screen is designed to be used intermittency, in other words, a few times each day. Because the weight of the fabric and the slat bar, nobody must remain under the screen. Fixing of the screen · Slide the threaded plates (50 mm long) along the T-grooves of the case at the right places chosen for the brackets but do not place them further than one meter from each end (see A). · Fix firmly the brackets with screws of nature and length appropriated to material constituting the wall or the ceiling (see the table for the weight of the screen ). Note : other mounting modes than the standard brackets can be used (consult your dealer). [. . . ] Incorrect use could make the guarantee void. Da-Lite reserves the right to modify its products in order to make technical improvements. 1000 maxi 1000 maxi A B H M10x70 C D E F F Hc M10x70 G 53178A0000 H I 03/2010 1 2 [. . . ]