User manual DA-LITE DWA SCHEMA

[. . . ] Make sure to recheck measurements of screen location before installation. Remove center support brackets (on 8' and wider screens only), reverse brackets and reinstall flush with the top of the box. MaSK MOTOR MaSK SURFaCe DRyWaLL SCReW aCCeSS PaNeL MaChINe SCReW PhILLIPS heaD SCReW ShIPPING BRaCKeT heX heaD SCReW FIGURE 1 SCReeN MOTOR PICTURe SURFaCe FIGURE 2 INSTALLATION 1. [. . . ] Install screen by raising unit into position between joists at one end only. Do not seal in until screen has been secured in position and properly tested for satisfactory operation. Carefully remove three shipping brackets by removing six hex head screws from case and three phillips head screws from aluminum slat. Make sure to review your electrical installation checklist and wiring diagram (included) for either 120 volt switch, 220/240 volt switch or low voltage control. !s NOTE: Must be installed in accordance with the requirements of the Local Building Codes, the Canadian Electrical Code (CEC), CAN/CSA C22. 1 and the National Electric Code (NEC), NFPA 70. Test installation by carefully running picture and mask surfaces up and down several times. NOTE: When rolled down, the picture surface should wrap fully around the roller. Picture and mask surfaces will automatically stop in the down position. (a) See installation instructions. (a) adjust "up" limit switch. See installation instructions (a) Replace motor assembly. (a) Defective brake. (a) Replace motor assembly. Printed in U. S. a. 6 77607 Rev. 3/95 LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS Da-Lite Screen Company, Inc. warrants its products to the original purchaser only, to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the original purchaser provided they are properly operated according to Da-Lite's instructions and are not damaged due to improper handling or treatment after shipment from the factory. This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or which has been tampered with or repaired by a person other than authorized Da-Lite personnel. Da-Lite's sole obligation under this warranty shall be to repair or to replace (at Da-Lite's option) the defective part of the merchandise. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment. To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses. [. . . ] If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment. To protect yourself against damage or loss in transit, insure the product and prepay all transportation expenses. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND MERCHANT ABILITY. [. . . ]