User manual DA-LITE DESIGNER MANUAL SCREEN

[. . . ] MAINTENANCE PROJECTION SCREEN MAINTENANCE Protect your screen by keeping it rolled in its case when not in use. [. . . ] 7/02 FOR WALL MOUNTING HARDWARE PROVIDED 2 ­ "V" Bars ( one is factory mounted to the back of the case; one will be mounted to the wall) 6 ­ Toggle Bolts, 4" 6 ­ Lead Shields, #10-14 x 11/2" 6 ­ Phillips Flat Head Wood Screws, #10 x 2" TOOLS REQUIRED Electric Drill Masonry Bit 5/16" (if mounting in solid masonry or concrete) Screw Driver, #2 Flat Tip (if using toggle bolts) or #2 Phillips (if mounting in solid masonry or concrete) INSTALLATION INSTRUCTIONS Determine the height of the top of the case from the floor. Hold the loose "V" bar to the wall at the height determined above (MAKE SURE IT IS LEVEL), and mark the location for the screw holes. To mount the "V" bar on solid concrete or masonry wall, drill 5/16" holes and insert the lead shields. Fasten the "V" bar to the wall using the #10 x 2" wood screws. If you are mounting to a hollow wall, drill 1/2" holes and insert the toggle bolts. Now set the case in place on the wall with the "V" bar of the case nestled into the "V" bar on the wall. FOR CEILING SUSPENSION Position and properly anchor screw hooks into ceiling, beam or other solid surface. Then proceed to use the two "D" rings that are factory mounted to the top of the case to hang the case securely. [. . . ] Do not allow it to roll uncontrolled into the case or damage to the screen is sure to result. Ceiling Allow a minimum of 11/4" from the ceiling Mount top of "V" Bar flush with top of Case 4" Determine measurement to the top of the Case 41/4" "V" Bar mounted to the wall "V" Bar mounted to the back of the Case at the factory Wall Floor line [. . . ]