User manual DA-LITE A111-4312 PARTS LIST

[. . . ] Required Tools: - - 9/16" wrench Drill motor Drill bits Hammer Solid Concrete Hardware Kit ­A101 1. [. . . ] Drill a 5/8" diameter hole into the concrete wall surface to the screw length. Make sure the threaded cone is snug onto the anchor so that the cone will stay on the anchor during installation. Insert the anchor, cone first, into the hole and tap it in place so that the top edge is flush with the concrete surface. Position the mount and insert the screw to engage the cone and tighten the screw until secure. Pull plastic loop toward yourself so channel is flush behind wall and slide cap down the plastic straps until cap is against the wall. Break plastic straps off at the cap by placing thumb in between the straps and on the cap and sliding thumb side to side. Use a flat washer where applicable. Figure 3 Metal Joist/Beam Hardware Kit ­A111-4312-4312 1. Position the mount, insert the screw, thread on nut and tighten until secure. [. . . ] Use a flat washer where applicable. Figure 3 Metal Joist/Beam Hardware Kit ­A111-4312-4312 1. [. . . ]