User manual DA-LITE 300

[. . . ] Use the wrapping material to lay the frame sections on to keep from scratching the frame. Unwrap the frame sections and orient them as shown in the Figure below. If your frame has the optional Pro-Trim masked borders, lay the frame with the borders facing down. Be sure to lay the frame on the wrapping material to keep the Pro-Trim clean. [. . . ] Insert the eyebolts through the frame and attach the hex nut to the eyebolt. Wall mount installation: There are 6 hanger brackets for smaller frames with a one-piece top frame rail. 8 hanger brackets are provided for larger frames with two-piece top frame rails. Consider the following before attaching the hanger brackets to the wall. - The hanger brackets must be anchored to a supported section of the wall, such as a wall stud. - The hanger brackets should be spaced on the wall so they line up with the S-hooks on the frame. This will prevent the lace cord from being pinched between the frame and hanger. - You will need at least 2" above the hanger bracket to mount the Series 200 frame (see Figure 2). - Frames with one-piece top frame rails should be supported at the center of the frame and about 2-4 feet from each end of the frame. - Frames with two-piece top frame rails should be supported about 2-3 feet on each side of the center joint and about 2-4 feet from each end of the frame. Attach 3 or 4 hanger brackets (as required above) at the same height along the wall. To determine the distance between the upper and lower hanger brackets you must measure the overall height of the frame. If your frame has the Pro-Trim border subtract 3-3/4" from the overall height. If your frame does not have the Pro-Trim border subtract 3-1/2" from the overall height. Using this number, measure down from each hanger bracket and mark the wall. 1 SERIES 200 INSTALLATION (CONTINUED) 2. Line up the lower hanger bracket with the mark and secure it to the wall. Remove the frame clamp from the hanger brackets and position the Series 200 frame on the hanger brackets as shown in Figure 2. Place the frame clamp onto the hanger bracket and secure it with the supplied hex nut. SERIES 200 FRAME HEX NUT FRAME CLAMP 2" MINIMUM UPPER HANGER BRACKET EQUALS OUTSIDE FRAME HEIGHT -3-3/4" WITH PRO-TRIM BORDER -3-1/2" WITHOUT PRO-TRIM BORDER (PRO-TRIM BORDER ADDS 1/4" TO FRAME HEIGHT LOWER HANGER BRACKET FIGURE 2 SERIES 300 INSTALLATION The Series 300 frame is supplied with eyebolts for ceiling installations and hanger brackets for wall mount installations. Ceiling installation: The frame is predrilled for the attachment of the eyebolts. There are 3 eyebolts for smaller frames with a one-piece top frame rail. [. . . ] If your frame does not have the Pro-Trim border subtract 4-1/2" from the overall height. Using this number, measure down from each hanger bracket and mark the wall. 2 SERIES 300 INSTALLATION (CONTINUED) 2. Line up the lower hanger bracket with the mark and secure it to the wall. Remove the frame clamp from the hanger brackets and position the Series 300 frame on the hanger brackets as shown in Figure 3. [. . . ]