User manual DA-LITE 26P REV 11-08

[. . . ] 11 / 08 Caution: This product is designed for ceiling installation only. Qualified personnel using the appropriate fasteners should mount the Pivoting DaLift. [. . . ] Remove contents from carton and examine for damaged or missing parts. SAVE THESE INSTRUCTIONS Required Tools: 7/16" wrench 1/2" wrench 9/16" wrench Phillips screwdriver CHANNEL MOUNTED TO STRUCTURAL CEILING (NOT SUPPLIED) 3/8" ALLTHREAD, NUTS, AND WASHERS (NOT SUPPLIED) SUSPENDED CEILING GRID AND TILE PROJECTED IMAGE TRIM 120V AC CONNECTION PROJECTOR 11/2" CONDUIT KNOCKOUT (FOR PROJECTOR SIGNAL CABLE) 1/2" CONDUIT KNOCKOUT (FOR WALL SWITCH OR OPTIONAL REMOTE RECEIVER) CEILING TILE CEILING TILE HOLDER CAP CEILING TILE HOLDER Figure 1 CHANNEL (NOT SUPPLIED) TRIM PROJECTOR CEILING TILE HOLDER CEILING TILE HOLDER CAP CEILING TILE Figure 2 DALIFT MODEL 26P 33P "W" "L" 231/2" 301/2" "W" 7" TO 141/4" 111/2" TO 183/4" "L" CENTERLINE OF ALLTHREAD Figure 3 5/16" CENTERLINE OF ALLTHREAD TO CUTOUT 2. Thumbnuts can be used for fine tuning projector position in next step. Figure 6 NUTS FOR RIGHT TO LEFT ADJUSTMENT NUTS FOR FORE AND AFT ADJUSTMENT 5. Figure 7 PROJECTOR DALIFT MODEL 26P "A" 161/2" 21" "B" 153/8" 197/8" 6. Determine where the projector will be located and make a hole in the ceiling and create a tile for the DaLift. CUTOUT "A" TRIM PIECE HAS TO FIT INSIDE CUTOUT SCRAP Figure 8 TILE HAS TO FIT INSIDE CEILING TILE HOLDER "B" 7. CHANNEL NOTE: ITEMS CALLED OUT ARE NOT SUPPLIED 3/8" ALLTHREAD 3/8" HEX NUT 3/8" FLAT WASHER 3/8" FLAT WASHER 3/8" LOCK HEX NUT Figure 9 "UP" 8. The "Stop" button is needed only for intermediate stopping. CONNECT TO 120V AC "STOP" "DOWN" WARNING! AVOID PINCH POINTS WHEN OPERATING DALIFT WITH THIS SWITCH CEILING TILE HOLDER CAP Figure 10 11. Install Ceiling Tile cutout from step 6 into Ceiling Tile Holder and assemble Ceiling Tile Holder Cap. Figure 13 CABLE STORAGE WHITE WIRE BLACK WIRE RED WIRE UP STOP RED WIRES WHITE WIRES BLACK WIRES DOWN 120V AC 60 Hz SUPPLY HOT COMMON GROUND BLACK (HOT) WHITE (COMMON) GREEN (GROUND) Figure 14 RECOMMENDED WIRE SIZE: 12 AWG Figure 15 RECOMMENDED WIRE SIZE: 2024 AWG Pivoting DaLift Plenum Cover 26P and 33P Form E454 Rev. Caution: This product is designed for ceiling installation only. Qualified personnel using the appropriate fasteners should mount the Pivoting DaLift and Plenum Cover. [. . . ] Remove contents from carton and examine for damaged or missing parts. SAVE THESE INSTRUCTIONS Required Tools: Phillips screwdriver REMOVE END PIECE Figure 1 A 2. Secure the Plenum Cover End to the DaLift using the fasteners from step 2. [. . . ]