User manual CORBERO F1250A-1

[. . . ] If the appliance has been transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. Service / Repair Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. [. . . ] One or more adjustable feet mounted on the base of the appliance make it possible to set it perfectly level. For the models designed to be built in the furniture it is necessary to follow the specific instructions regarding building in. Fig. 1 100 mm A 10 mm B 10 mm NP006 Rear spacers In the plastic envelope containing the Operating Instructions are also included two wall spacers to be fitted into the special openings provided on the back of the appliance. Push-fit the spacers into the openings, making sure that arrow (A) is positioned as per Fig. 2 and then turn the spacers through 45° until they lock in (arrow in vertical position). 2 45° D039 4 Power connection Before plugging in the appliance to the mains socket, check that the voltage and frequency indicated on the appliance's rating plate are the same as those provided by your home power supply. For operation at different voltages, a suitable transformer should be used. The supply-lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualified electrician, in accordance with existing safety regulations. The manufacturer declines to accept any liability if this accident-prevention procedure is not followed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the finish. 5 Door reversibility Unplug the appliance before performing the following operations: Carefully lay the appliance on its back. Reassemble the door, inserting the upper hinge pin into the bushing on the door. The holes that are not used are to be masked with the plastic plugs removed. 3 Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. D185 Fig. 5 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. For operation with different voltages, a suitably sized auto-transformer must be used. PR184 TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. GB 6 USE Start-up - temperature regulation After plugging the appliance, turn the thermostat knob located at the top right of the fridge, clockwise to the required position (apart from position «O» - off). Temperature is kept constant automatically and can be increased by turning the knob to lower numbers, or reduced by turning it to higher numbers. [. . . ] Remember that, in this condition, the refrigerating compartment temperature might drop below 0°C. Make sure that the frozen foods have been correctly stored by the retailer. Make sure that the interval between the time when you buy the frozen foods and when you put them in the freezer is short. Do not exceed the dates of expiry marked on the packages by the manufacturer. [. . . ]