User manual CLATRONIC VL 2590 S NEW

[. . . ] Before commissioning this device please read the instruction manual carefully. â· Please keep these instructions, the guaranty certificate, the sales receipt and, if possible, the carton with the inner packaging! [. . . ] Under no circumstances must the device be placed in water or other liquid, or come into contact with such*). â· Should the device become moist or wet, remove the mains plug from the socket immediately*). Overview of the components 1 Front protection grid 2 Fastening hooks 3 Safety bolt 4 Propeller fastening ring 5 Propeller 6 Safety bolt for the rear protection grid 7 Rear protection grid 8 Motor shaft 9 Motor 10 11 12 13 14 15 16 17 Gear casing Stand/gear casing connection screw Height adjustment locking screw Stand tube Cover cap Base cap Base Setting knob The device must be completely assembled before use!To line the base cap (15) push the cover cap (14) to the lowest position on the stand tube (13). Insert the rear protection grid (7) in the relevant slots and screw on the safety bolt for the rear protection grid (6) by turning it clockwise. Screw on the fastening ring for the propeller (4) by turning it clockwise. Hook on the front protection grid (1) and fasten it with the supplied fastening plate and screw. Make sure that the mains voltage to be used matches that of the device. You can adjust the inclination angle by tipping the blower casing with both hands. You can adjust the height of the stand by loosening by hand the height adjustment locking screw (12), hold the fan by the gear casing and pull up. Operating To select the fan speed use the selector on the front to set one of the following speeds: 1 = slow, 2 = medium, 3 = fast. Blower Direction/Oscillation You can choose from the two following options: 1. Turn the device carefully with by hand by holding the fan on the sides and turning it either to the left or to the right until the limit stop. If the device is very dirty wet a cloth with water and then wipe the device dry once you have finished. [. . . ] The cleaning, servicing and replacement of wear parts are not covered by this warranty and hence are to be paid for. Once the warranty has expired, repairs can be carried out by specialized technicians or repair services against the payment of the service. [. . . ]