User manual CLATRONIC TA 2618 NEW

[. . . ] Before commissioning this device please read the instruction manual carefully. â· Please keep these instructions, the guaranty certificate, the sales receipt and, if possible, the carton with the inner packaging! [. . . ] Under no circumstances must the device be placed in water or other liquid, or come into contact with such*). â· Should the device become moist or wet, remove the mains plug from the socket immediately*). Special safety information for this unit Always watch the unit while it is being used!) Do not lay the food to be toasted directly on the toaster, but always lift up the toasting top before toasting. In order to remove the protective layer on the heating coil you should operate the machine approximately three times when it is empty. Overview of the Components 1 2 3 4 Toast slot Slide lever Browning level selector Thawing function 5 6 7 8 STOP key Crumble tray Bread roll accessory Bread roll accessory locking device Only connect the unit to a properly installed and earthed power socket (230 volts, 50 Hz). Insert 1 slice of bread per toasting slot (1) and push down the slide with the lever (2) until it clicks into place. To mount the bread roll accessory the locking device for the toasting accessory (8) on the upper right hand of the appliance must be pushed in. Thawing Function The thawing function is used to preheat the bread and to toast it later on thus increasing the toasting time. Insert the slice of bread in the toast slot (1) (1 slice for each slot). Turn the browning level selector (3) to the desired browning level and pull down the lever (2) until it snaps into place. 26 Pull the mains plug out of the mains socket before you clean the unit and allow the unit to cool down. Pull the crumb tray (6) out, remove any bits of bread and put the tray back in. This appliance conforms with the CE directives for radio interference suppression and low-voltage safety and has been built to meet current safety requirements. [. . . ] The cleaning, servicing and replacement of wear parts are not covered by this warranty and hence are to be paid for. Once the warranty has expired, repairs can be carried out by specialized technicians or repair services against the payment of the service. [. . . ]