User manual CLATRONIC SPM 2798 NEW

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance. [. . . ] If you would like to give your shoes a special shine, use a shoe polish that is specifically suited to your shoes. Wait until this has completely dried and then polish your shoes thoroughly with one of the two outer brushes (6/8). Note: Do not mix up the brush which is used for coloured polish with the colourless brush, as otherwise the result will be far less satisfactory. When you have finished polishing your shoes, press the ON/OFF switch to turn the machine off. Through the viewing window of the container flap (4) you can see whether the container needs to be filled or if there is still enough polish in it. If the shoe polish comes out very slowly, new polish can be filled in. Press in the device fitted to the left side of the container flap and then fold it open. Remove the empty container and release the turn-lock fastener by unscrewing it in an anticlockwise direction. Press the valve on Illustration 1 the bottom of the container in order to prevent the Valve polish leaking out when the container is being filled. After filling up the container, tighten the turn-lock container fastener again (illustration 1). The valve is opened again to ensure that during use the polish is deliSpring Turn-lock vered more evenly. Now insert the filled container fastener back into the machine and close the container lid. Please ensure that when the lid is closed its locks into place correctly in the housing. Each time the machine is cleaned or serviced make sure the mains plug has been removed from the socket beforehand. The dust and dirt on the rubber mat can be easily removed with a vacuum cleaner, or simply take the mat and hold it under running water. Allow the mat to dry fully before replacing it in the machine in order to avoid damage to the machine. The metal housing (1) can be cleaned when necessary with a slightly damp cloth - without additives. Release the screw(s) (10) by turning in an anticlockwise direction with a screwdriver, and then pull the brush(es) down. [. . . ] If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]