User manual CLATRONIC SLS 618 NEW

[. . . ] When using external mains supply, pay attention to the correct polarity and voltage. Assemble the device in such a way that the available ventilation openings are not covered. Should the device become damaged, in particular the mains supply cable, do not operate the device any longer, but rather have it repaired by an expert. [. . . ] With the help of an adhesive strip you can then attach the loudspeaker wires to the bottom of your wire. Then guide the loudspeaker wires through the tube by pulling on the wire. Attach the loudspeaker holder (bracket) to the upper end of the foot and insert the loudspeaker into the mounting. The cinch plug of the loudspeaker cable is now connected to the AUDIO OUTPUT of the subwoofer according to the loudspeakers. AUDIO OUTPUT: Outputs on the right and left for connection of the front loudspeakers (R Front right, L Front left). Output for connection of the centre loudspeaker (CEN Centre) output for connection of the surround loudspeakers on the right and left (RS Surround right speaker, LS Surround left speaker) Mains lead Correct connection is as follows: When you have connected all loudspeakers and devices as described you can insert the mains plug of the subwoofer into a correctly installed 230 volt, 50 hertz power socket. Please ensure that the polarity is correct (see the floor of the battery compartment or the inscription on the outside)!If the remote control is not used for a prolonged period, remove the batteries in order to prevent battery acid leaking. Warning: batteries are not to be disposed of together with domestic wastes. Dispose of the used batteries at the relevant collection bin or at your dealer's. When the remote control is used, care should be taken that there are no objects between the remote control and the central loudspeaker. These objects prevent the infrared beam of the remote control from reaching the receiver of the central loudspeaker. It is then not possible to control the television with the remote control. CENTER +/-: With these buttons you can set the volume of the centre loudspeaker. BASS (SUBWOOFER) +/-: With these buttons you can set the volume of the subwoofer. SUR (SURROUND) +/-: With these buttons you can set the volume of the surround loudspeakers. MUTE: With this button you can switch off the loudspeakers without changing the volume. NOTE: When switching off this function ensure that the overall volume is not set to maximum! [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid! [. . . ]