User manual CLATRONIC RA 2725 2

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance. [. . . ] Ensure that a safety distance is maintained between the power cord and the housing. In order to avoid overheating it is important that the air inlets and outlets are kept clear. This radiator is not suitable for use in bathrooms, washing rooms or rooms which are used in a similar manner. The radiator must never be placed in a position where it could fall into a bathtub or other water container. The radiator should not be placed directly below a mains power socket. If the radiator should fall over, first remove the plug from the socket and allow the radiator to cool down before returning it to an upright position. to do so , place the radiator upside-down (hold the underside facing upwards); avoid hard surfaces. In the case of oil radiators with 5 to 10 fins, the rollers should be attached in the right position between the first and second and between the last and penultimate fins. For models with 5-6-7 and 8 fins, the U-shaped roller carriers are used. For oil radiators with more than 10 fins, the straight roller carriers between the second and third fin must be attached to both ends. Pass the U-shaped clamps through the holes of each roller carrier and then tighten the wing nuts. Q qq qqq = low power = medium power = high power The control lamps light up during heating operation. (only for radiators with heater blowers) In order to heat up the room more quickly the blower can be switched on. ­ only the heater blower is running qqq ­ the heater blower + first and second heating level Please note that this paragraph only refers to the following model: RA 276 G In order to find the ideal thermostat setting, turn the thermostat control clockwise to "max". As soon as the desired temperature has been reached, turn the thermostat regulator slowly anticlockwise until the radiator switches off. Always remove the power cable from the socket and allow the radiator to cool down before cleaning it. [. . . ] *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]