User manual CLATRONIC MC 1017 CD NEW

[. . . ] The built-in safety switches should prevent the user being exposed to dangerous laser light, which is invisible to the human eye, when the CD compartment is opened. Under no circumstances should these safety switches be bypassed or manipulated, as this could result in a danger of exposure to the laser light. Remove any transport safety equipment on the CD and cassette sections. A dry, flat, non-slip surface on which the device can be easily operated. [. . . ] During this procedure the listener can check the contents of all the channels and interrupt the test run by pressing the P. Push a recorded audio cassette, with the tape downwards and the listening side facing forwards, into the compartment. If necessary, run the tape forwards or backwards as required by means of the = forwards (27); = backwards (26). Always press the / Stop/Eject button (28) when switching over or stopping the tape running function. When the / Stop/Eject button (28) is pressed again the flap of the cassette compartment opens. Make sure that the cassette is not protected against dubbing (the copy protection tab on the upper edge of the cassette must not be broken). Select the recording source with the function selector switch (4) (8 on the remote control) and then start this source. Recording can be briefly interrupted with the II Pause button (29) or stopped with the / Stop/Eject button (28). Insert one or both microphones (not supplied) into the microphone input socket(s) (12/14). Recording can be briefly interrupted with the II Pause button (29) or stopped with the / Stop/Eject button (28). This is how you play a CD Insert a music CD with the label facing upwards on the central button and close the CD deck cover. After a few seconds the total number of songs/tracks is shown in the display (19). Press the PLAY/PAUSE button (20) (3 on the remote control) in order to play the CD. The desired volume can be set using the VOLUME buttons (2/3) (2/5 on the remote control). To remove a CD, press the STOP key (21) (1 on the remote control), open the CD deck with the OPEN/CLOSE key (35) and take out the CD carefully. If the button is kept pressed down, the machine starts to search through the tracks. (FORWARD) SKIP I (16) (7 on the remote control): With this button you can jump to the following track or the next track but one etc. If the button is kept pressed down, the machine starts to search through the tracks. REPEAT (9): Press once: the current track is repeated continuously, (REP lights up in the display. Programmed Play This can be used to program any desired sequence of tracks. 1" (storage location) and the track number are shown II buttons in the display (19) and the MEM display flashes. Use the SKIP (16/22) (6/7 on the remote control) to select the desired track and then press the MEMO button again. [. . . ] During the life of the guarantee any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The guarantee services do not entail an extension of the life of the guarantee nor do they give rise to any right to a new guarantee!Without proof of purchase no free replacement or repair will be carried out. For repairs or replacement during the life of the guarantee return the device in its original packing together with the proof of purchase to your dealer. [. . . ]