User manual CLATRONIC KA 2888 OTHER MANUAL

[. . . ] Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. the appliance is designed exclusively for private use and for the envisaged purpose. Do not use it outdoors (except if it is designed to be used outdoors). [. . . ] Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. In order to leave the adjustment mode press the TIMER button twice or wait for 10 seconds. Fill the machine to the level corresponding to the number of cups required with cold water. Insert a paper filter (size 1x4) in the filter funnel and fill with ground coffee (approx. By removing the pot, before the water runs through the filter completely, it avoids that the coffee drips on the base. If there is still water in the tank or filter, make sure that the pot is placed back under the filter to avoid overflowing. Switching on the coffee machine directly: Please follow the instructions under points 1-5 "Initial Operation". B) The unit switches itself off automatically about two hours after the brewing. If you wish to switch the unit off manually or to deactivate the timer, press the START button repeatedly until both LEDs go out. In order to leave the adjustment mode press the TIMER button once or wait for 10 seconds. If you wish to switch the unit off manually or to deactivate the timer, press the START button repeatedly until both LEDs go out. Descaling is necessary when the time needed to prepare coffee becomes considerably longer. Only commercially available descaling products based on citric acid should be used. Before cleaning the machine you should always remove the mains lead and wait until the machine has cooled down. The coffee pot and the filter pad should be cleaned by rinsing in cold water. [. . . ] Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs. [. . . ]