User manual CLATRONIC KA 2535 OTHER MANUAL

[. . . ] Before commissioning this device please read the instruction manual carefully. Please keep these instructions, the guaranty certificate, the sales receipt and, if possible, the carton with the inner packaging! The device is intended exclusively for private and not for commercial use! [. . . ] Never open the water tank lid while boiling water as this could lead to scalding. Before making coffee in the machine for the first time rinse two to three times with cold water in order to clean the machine. Make sure that the machine is switched off (operating switch on "OFF"). Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. Fill the machine to the level corresponding to the number of cups required with cold water. Place a paper filter (size 1 x 4) into the filter funnel and fill it with coffee powder (approx. If you would like to keep the remaining coffee warm, the switch must remain in the "EIN/1" position. The hot plate will keep the coffee warm until you switch the machine "AUS/0". If you wish to switch the unit off manually or to deactivate the timer, press the EIN/AUS button repeatedly until both LEDs go out. The unit switches itself off automatically about two hours after the brewing. In order to make the most of the coffee powder for 1-3 cups of coffee, the brewing time can be extended by activating the aroma intensification mode. The aroma intensification mode is shut off automatically after approximately 5 minutes. Descaling is necessary when the time needed to prepare coffee becomes considerably longer. Only commercially available descaling products based on citric acid should be used. Before cleaning the machine you should always remove the mains lead and wait until the machine has cooled down. [. . . ] The cleaning, servicing and replacement of wear parts are not covered by this warranty and hence are to be paid for. Once the warranty has expired, repairs can be carried out by specialized technicians or repair services against the payment of the service. Body 1 - 3 jsou identické s body pro pístroje bez casového spínace. [. . . ]